I want to ask about the design done by ansys maxwell then i made the thermal coupling ( thermal transient ) using machanical ansys ...the material of piece is changed from copper to structural steel ...how can I avoid this?
And how can I add the frequency and current using mechanical ansys as shown in picture below?
Cosmin Preda
Hello, in my opinion, the easiest way to do this is by doing a separate analysis for material change (from copper to structural steel).
Maybe it is possible to do it without changing, but this is the easiest way.
Good luck!
0 votes
0 thanks
Aws Hashim Al-Jrew
I also try it ..but the program does not response to the change ...thanks for your answer
0 votes
0 thanks
- Badges
- Science topic
More Aws Hashim Al-Jrew's questions See All
Similar questions and discussions