12 March 2020 3 2K Report

when adding the Fe compound in the water it gets deprotonated and from strong acid.

1.adding base leads to salt formation

2.adding buffer solution leads to Fe concentration change.

More Manikandan Venkatesan's questions See All
Is there any selective media for isolating Clostridium Perfringens from clinical sample?

Hello, I am currently working on isolation of Clostridium perfringens type D from the feacal samples of sheep. I am getting pcr positive from clinical sample but I am facing problem in isolation...

09 March 2024 7,428 1 View

How do we plot gain versus frequency plot in CST tool while designing an antenna?

I think there is no direct option to plot gain versus frequency in CST. kindly give solution

09 October 2023 8,738 3 View

The pixels of an image is scanned from left to right and from the top to bottom. each new pixel is predicted by the avg of the pixel above?

the pixels of an image is scanned from left to right and from the top to bottom. each new pixel is predicted by the avg of the pixel above and one to the left.

01 October 2023 4,525 1 View

API standards for chemicals used in hydraulic fracturing (Oilfield chemicals)?

Is there any standards in American Petrochemical Institute available similar to pharmacopoeias? for the chemicals used in oilfield industry

15 September 2023 1,955 0 View

Can anybody suggest how to make a hard mask from Ledit file for photo lithography?

I have only ledit file how to make hard mask for mask aligner. is this possible to do using laser writer or engraver. how to make pattern?

09 September 2023 903 1 View

In the Protein drug conjugation, How to calculate the Protein drug ratio by UV method?

I am performing the synthesis of a protein-drug conjugation. After the conjugation, how do I calculate the concentrations of the protein and drug using UV? Kindly provide examples of calculations.

17 August 2023 8,114 0 View

How can I model a contact problem in DIANA FEA?

Hi all, I am trying to model a contact problem in DIANA FEA. I went through the DIANA manual and found that DIANA has contact elements which imposes the contact constraint. But there aren't any...

02 August 2023 7,405 3 View

Is it possible to use an converter to charge the battery through supercapacitors?

I want to know whether any possible ways to charge the battery using supercapacitors with the help of converters. if yes what type of converters are prefered to charge the battery?

16 July 2023 154 1 View

Is there any non-denature approaches to solubilize protein aggregates or Triton insoluble protein aggregates?

I have isolated the Triton insoluble protein aggregates from the cell culture media and blood serum. I got the pellet (insoluble protein) in the final stage of the isolation process and it’s not...

21 March 2023 9,946 10 View

How to prepare input data for discrete wavelet transform?

i would like to do trend analysis for long time series data using multi resolution wavelet analysis. i am struck with preparing input data to analyze using discrete wavelet transform. i have tried...

21 December 2022 1,006 3 View

Similar questions and discussions
AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

Comment ajouter une recherche ?

En suivant toutes les étapes mentionnées sur (ajouter une recherche) il me signale erreur, ressayer, j'ai essayé plusieurs fois, sans succès, toujours il me signal erreur, ressayer

02 August 2024 9,719 1 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

How to select target material for X-Ray generation?

Generally, the target material is Mo, Co, Cu, Fe, Cr, etc, so on what basis should we choose this material?

31 July 2024 5,824 0 View

EDTA buffer solution?

Hello everyone! How can i prepare EDTA buffer solution (pH 8.2) to determine GSH levels? Thank you in advance.

29 July 2024 4,374 1 View

Whether i can preserve leaves samples in 2.5% glutaraldehyde in 0.05 M phosphate buffer, pH 7 for coming several weeks for further LM study ?

I want to preserve the sample leaves for the LM study of the stomata and conidia analysis. Whether 2.5% glutaraldehyde in 0.05 M phosphate buffer with pH 7 can be applied for preservation.

29 July 2024 8,560 0 View

What is the solubility of Iron (+3) in Bismuth Oxide?

Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco

29 July 2024 2,163 1 View

What are cultural bereavement practices of Jamaica that do not conflict with the Christian faith?

I am writing my thesis on the enculturation of Jamaican grief and bereavement practices that enhances their Christian faith and not diminish it.

23 July 2024 3,837 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close