Hello everyone. I want to apply the Heaviside function on the delta(phils) as shown in the figure. Can I apply the step function as a Heaviside function shown in the figure?
The substitute to the Heaviside function in the Camsol software is the "flc1hs" or "flc2hs". For example, you can define the following Heaviside function in the software as follows:
See this https://www.researchgate.net/post/To_define_Heaviside_function_in_COMSOL?_iepl%5BgeneralViewId%5D=M0DQQaceoZY3JKoQgTnbQ2u4yYghdGPBXkYm&_iepl%5Bcontexts%5D%5B0%5D=searchReact&_iepl%5BviewId%5D=d1M07NipIXB3S0Dqlv4CQZoYgS91uxYEDGMv&_iepl%5BsearchType%5D=question&_iepl%5Bdata%5D%5BcountMoreThan20%5D=1&_iepl%5Bdata%5D%5BinteractedWithPosition20plus%5D=1&_iepl%5Bposition%5D=24&_iepl%5BrgKey%5D=PT%3A5ea5e5440d92fc4d0669c804&_iepl%5BtargetEntityId%5D=Q%3A5ea5e5440d92fc4d0669c804&_iepl%5BinteractionType%5D=questionView
Mahdi Khatibi : Can you please explain why size of transition zone should be 1e-15 ? Because as shown in the figure transition zone is specified as phils=0.5
René Christensen : This heaviside function is somehow related to the thickess of the interface. The question in the link that you have shared is asked by me only. I think, I can use flc2hs here too but I'm confused about the parameter I should use in it. Should it be interface thickness, phils or temp dependent ?
The substitute to the Heaviside function in the Camsol software is the "flc1hs" or "flc2hs". For example, you can define the following Heaviside function in the software as follows: