Dear Friends,
I performed CFD simulation using CFX and then try to import the pressure pattern from CFX results to Structural module.
On some of the wall, the pressure pattern is exactly imported (see image1) while in some case the only single pressure is imported and applied (see image2)..
Kindly help me why this problem occured. I want to import the exact pressure pattern as obtained from CFX analysis.
Thanks in advance
Regards
Niaz
Hello Niaz,
It could be because you might not have defined the boundary correctly. You should have the same boundary in CFX while importing pressure data in Structural.
If that was not the case, when you import any pressure boundary from CFX, you get vectors pointing over the surface. This should have different colors (like what you get in CFX). Please try to verify from there.
Sailesh
Dear Saliesh Chitrakar,
Thank you for your response.
The boundary and geometry of both the CFX and structural simulation is exactly the same... In fact, If we try to import pressure from other areas then it transform the exact pattern, but when try to import pressure from the face (shown in image 2), it failed to apply the exact pattern.
- Badges
- Science topic