Fluid chemistry associated with retrogressed eclogites?

21 November 2013 0 4K Report

During retrogression of eclogites to amphibolite eclogites, a fluid phase is involved. What are the geochemical fingerprints of such fluids?

Badges
Science topic

More I. Baziotis's questions See All

What is initial intensity in Stern-Volmer plot for quenching studies in solution state?

I was performing quenching studies in solution state. While plotting the Stern-Volmer graph, which intensity should I use as initial intensity (I0). For example, I take 1 ml of 0.1 M fluorophore...

25 June 2024 5,385 1 View

Is Chromium degradation research is banned in India? Why?

Expecting a technical reason

19 June 2024 4,495 0 View

Why liposome size increase during storage?

My liposome is a non-phospholipid liposome (sterosome) composed of palmitic acid and cholesterol, 20mg of palmitic acid and 70mg of cholesterol. After several months of storage in a refrigerator...

18 June 2024 7,459 5 View

Why liposome size increase during storage and after release?

My liposome is a non-phospholipid liposome (sterosome) composed of palmitic acid and cholesterol, 20mg of palmitic acid and 70mg of cholesterol. After a month of storage in a refrigerator at 4...

18 June 2024 1,858 1 View

What is covering the wall of tio2 that causes the side view not to be visible?

It doesn't seem like nanowire, because the Tio2 surface is clearly visible.

27 May 2024 6,319 0 View

Why usually researchers experiment with increased dosage of contaminants than found in actual effluent in research process?

I am searching for a technical reason that anyone could suggest please?

08 May 2024 6,032 2 View

Why my DNA bands are not visible but my TrackIt Invitrogen ladder bands are after running them on pre-stained (BrEt) agarose gel?

After staining and solidifying my agarose gel, I load the first well of the dried agarose gel with the TrackIt Ladder (10488058) from Invitrogen and load my unstained DNA samples into the other...

22 April 2024 635 4 View

What is the application formula for drug release kinetics from liposomes through dialysis membrane?

Hello fellow scholars, I would like to know if I measure the drug release of my liposome through a dialysis membrane, how to solve the model that this device may cause [two-stage release]? Of...

09 April 2024 370 0 View

¿Como puedo transformar una variable donde predominan los ceros y también hay valores altos dispersos?

Tengo una columna de la variable de "precipitación" donde predominan los ceros y hay valores altos. No he podido transformarla para obtener una distribución normal, ya he usado métodos de log,...

05 April 2024 8,427 1 View

What are the reliable spectrophotometric methods for compounds with overlapping spectras?

I have a fluorophore and its emission is quenched on adding analyte compound. The overlapping spectra of compound and analyte make UV-vis absorption analysis unreliable. The analyte mixture...

03 April 2024 7,914 1 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Handling Missing Data and Building a Predictive Model with Incomplete Information ?

I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...

10 August 2024 4,005 2 View

Is it possible to use the Fused Deposition Modeling (FDM) to additively manufacture interconnected porous structure generation of >100-200 micrometer?

Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...

09 August 2024 7,892 0 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Can you suggest reliable sources defining "3D mesh" and "3D city models"?

Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...

06 August 2024 9,986 2 View

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

What are the shear and normal stiffness values of an LLDPE liner in 3D numerical modeling of a stockpile?

I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...

05 August 2024 3,665 0 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View

Given the current level of natural phenomena cause by the climate change and environmental pollution, will the AI find the technological solutions?

AI-driven technologies offer previously unheard-of capabilities to process enormous volumes of data, extract insightful knowledge and improve predictive models, according to the UN’s World...

31 July 2024 9,733 3 View