Flac 3D 6.0 for dynamic analysis?

More Peter Antwi Buah's questions See All

I have a time series data of some biochemical studies ( DNA and Chromosomal damage) which I intend to use to further predict into future ?

I have a time series data of some biochemical studies ( DNA and Chromosomal damage) which I intend to use to further predict into future without necessarily conducting the assay for an extended...

23 February 2021 7,842 1 View

No mRNA increase in PCR after successful transfection in ARPE-19 cells ?

Hello, i am a bit curious about my results. I transfected the human cell Line ARPE-19 with a Plasmid containing a GFP tagged p53 (p53-GFP, Plasmid #11770). After 24h i checked under the...

18 February 2021 3,811 7 View

Do there exist stand-alone permanently in-ground soil-moisture sensors with an installed GSM module, for outdoor use?

Am searching for a stand-alone permanently in-ground soil-moisture sensor with an installed GSM module, for outdoor use. The idea is for the sensor to send a moisture reading via a cellphone text...

04 February 2021 2,047 4 View

What is the easiest way to remove the water from organic solvents?

Hello everyone! I have one question. I have couple of solvents and all of them were pure when they were bought but after some months or years of storage after opening I am not 100% sure about...

03 February 2021 2,154 8 View

Virus neutralization assay in BSL2 lab?

Hi I want to set up a virus neutralisation assay such as PRNT or FRNT at my lab (BSL2), but im uncertain of the bio safety requirements that has to be fulfilled in order to work with...

01 February 2021 5,626 3 View

Using LINK11 to Apply force in ANSYS APDL?

I'm trying to use LINK11 to apply a force as if it was a cable pulling a structure twowards a point in ANSYS APDL. When I solve the model, the deformation of the overall structure is far too...

30 January 2021 7,919 1 View

Cytoflex Flowcytometer, clotting issues and cleaning procedures?

We have been having clotting issues with our Cytoflex S from Beckman Coulter. Back in December 2020, we had to have the tubing system and sample needles replaced, but we are beginning to observe...

28 January 2021 6,897 2 View

Difficulties purifying Outer Membrane Vesicles using a Sucrose Density Gradient: Unable to detect any protein after this process?

I'm currently trying to purify Outer Membrane Vesicles (OMVs) following their extraction from the bacteria I'm working with. After the initial extraction the concentration of protein seems good...

27 January 2021 6,852 3 View

What excamples do you know wasting unused contents of "empty" packaged products?

Most of us use tooth paste more times a day. The empty tube we throw away. I wondered how empty the tube really is. This does not sound being Research? I began to collect empty tubes...

19 January 2021 808 3 View

What is the largest disadvantage in using of face masks at present? What would you like to be improved?

We all use face masks many hours a day. I wonder what are your items you like to be improved. We have the opportunity to write an application for support to a sponsor. Your answers will help us a...

18 January 2021 1,311 4 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Gel electrophoresis result for total RNA samples, 1.5 Agarose gel was used, How to improve the integrity of RNA?

Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue

02 March 2021 5,433 5 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Alireza Rashiddel

Hello

Check the dynamic boundary conditions and damping and mesh size.

Give me more information on your project!

Best,

Rashiddel

Lecturer FLAC 2D - 3D software

Mohammad Azarafza

Dear Peter,

Regarding the dynamic analysis in FLAC3D you have to control the boundary condition and fixed regions, loading conditions, and material specification in model. Using dynamic loading required to applying a dynamic input boundary condition at either the model boundary or internal gridpoints. Please check the boundaries, loading and materials properly.

Bests,