Is it possible that insecticides from same group and same mode of action may not show cross resistance?

I could not find any cross resistance between two insecticides from OP group, is this possible?

14 January 2021 9,625 3 View

What is the role of top counter electrode when using perovskite thin-films in photoelectrochemical application?

I am currently working on perovskite based photoelectrodes, but I do not want to replace the counter electrodes including Ag, Au, will it have serious issue in the PEC performance?

13 January 2021 3,408 2 View

Is it possible for Cre positive mice to be negative for flox reporter gene (eGFP)?

I was genotyping some mice tail snips. It is a Cre Lox reporter mouse. The Cre is expressed using CRH promoter in the mouse brain and eGFP is the reporter gene. I isolated g-DNA and used it for...

12 January 2021 6,875 3 View

Which statistical test is appropriate to analyse Likert Scale data?

Recently, I conducted a research survey based on 5 points Liker scale data. All the options in every research-based questions are correct. The options do not depend on each other and are separate...

28 December 2020 2,347 13 View

Insecticide resistance without selection pressure, if possible?

What could be possible reasons for insecticide resistance among insects from areas which have very little exposure of insecticides or there is no selection pressure and the areas are rich in...

07 September 2020 1,346 15 View

When to add H2DCFDA dye before or after treatment and why?

When to add ROS generation binding dye H2DCFDA, before or after treatment and why?

07 September 2020 4,962 3 View

Is it possible to use MAC address of a device as an authentication key for accessing a file?

is it possible to use a MAC address of device as an authentication key for accessing a file? can this be implemented manually ? like if I want a specific device to access a file( i have no access...

22 July 2020 2,667 15 View

Is there any error bar in frequency calculations using Gaussian09, suppose in DFT-B3LYP and 6-311+G(d) calculations?

In frequency calculations in Gaussian09 using DFT-B3LYP and 6-311+G(d) functional and basis set, we know that scaling factor is applied to correct the obtained frequencies. But is there any...

26 June 2020 3,155 4 View

Does anyone know a good IHC protocol for FGFR1 detection on floating brain sections?

I am trying to standardize IHC for cFOS and FGFR1 detection on rat brain sections. I use 40 micron sections and have had good results for cFOS detection. But I have not had any positive results...

25 March 2020 582 5 View

Any researcher working on Alkaloids in India?

Any researcher working on the alkaloids(Trichodesmine, Junceine, Riddelline, Senecionine, Seneciphylline, Lycopsamine and Intermidine) in india. Need help regarding this.

03 March 2020 1,060 4 View

What are the values needed for gabor filter's parameter for cifar10 data?

Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...

03 March 2021 6,317 1 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is a lucid standard comprehensive book to guide on psychological scale construction and its standardization?

02 March 2021 7,082 3 View

Shall I skip the measurement model in SmartPLS?

Hello everyone, I had run a mediation model in SmartPLS using questionnaires that were already validated among my statistical population. A professor who edited my paper -though she is not...

01 March 2021 3,052 3 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

Is it necessary to report effect size (ES) in statistics of biomedical research given that we already report p values routinely?

Pls share your thoughts

01 March 2021 7,330 4 View

Which reagent is best among 'Dimethylglyoxime" and "Dithiothreitol" for spectroscopic determination of Nickel ?

What I think is Dithiothreitol. As it is water-soluble and does not form a precipitate. But, the thing is it contains sulphur which is quite hazardous to aquatic animals.

01 March 2021 8,374 4 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

PUC19 as a transfer plasmid for lentiviral delivery?

Hello, Is it possible to use pUC19 as a transfer vector to be packed in using the second generation viral particles packaging system( pMD2.G; psPAX2 plasmids)? As far as I understand it there is...

28 February 2021 4,868 2 View

How could I take into consideration the weights of observation in a system of seemingly unrelated regressions (SUR) in rstudio?

I build a model of 4 regression equations (probit and OLS) in R studio. I need to take the weights of observations into consideration. While it is simple to do so for every regression equation,...

27 February 2021 1,233 1 View