Dear Shahmoradi,

I cannot understand the time delay during electrospinning. Can you please elaborate? However, time of deposition on the collector only affect the density of nanofiber deposited, porosity and pore-size distribution.

Thanks

It depends on 2 situation

1.volatile solvent:it definitely affect the density of nanofiber deposited, porosity and pore-size distribution.

2.Non-volatile solvent:it not much affect the results

thanks for the answers.

I have to turn off electrospinning device. Then I turn it on and continue fabricating of PCL scaffold (Unfortunately device has problem!!!)

Does it have effect on nanofibers?

This should not matter, as long as you do not allow an excess of solution to build up at the tip of the spinneret.  I would recommend wiping the tip clean just before recharging it.  In my experience a large droplet can cause Taylor cone instability (leading to anomalous fibre size/distribution) and you may even find the entire drop is drawn onto the collector, in which case the solvent will dissolve your previous fibres.

thank you Mr Harrison