Did anyone has reported the eggshell SEM image in flower like structure ?

Chingakham Chinglenthoiba @Chingakham_Chinglenthoiba

01 January 2017 0 8K Report

if anyone here read the paper about eggshell and reported the SEM image as flower-like structure then please let me know the name of the paper.

Badges
Science topic

Similar topics
Papers

More Chingakham Chinglenthoiba's questions See All

How does the nano fiber diameter decrease while loading of MWCNT in ABS polymer solution during electrospinning ?

I have electrospun pure ABS solution and measured the diameter and it was measured as 500s nm averagely. But surprisingly the fiber diameter decreases to 100s nm averagely while loading of MWCNT....

08 September 2018 2,816 1 View

Can we check molecular weight of the sample in Malvern Nano ZS series ?

we have light scattering instrument of Malvern Nano ZS series. I need to do a studies on change in Molecular weight of the sample. But im unable to perform it. I have seen a drop down menu in the...

05 June 2018 7,855 0 View

Unknown RI and Absorption Coeff of the material in DLS for size distribution ?

We have Malvern DLS Zetasizer instrument in our lab. I need to determine the size analysis by DLS method. I need to input the properties like RI and absorption Coeff of the material. Is there any...

09 October 2017 2,754 0 View

What are the major following steps to follow for purification of waste cooking oil for transesterification ?

I have collected some waste cooking oil from hotels and it contains lots of left over fried items and loaded with carbon (black soot). I have to use it for my research work but finding hard in...

08 September 2017 6,326 0 View

How does a layer structure material enhances in catalytic properties of the material ?

After a novel synthesis method of a compound, I have found it as layered structure when I observed in SEM. This material was not having the layer structure before synthesizing it with the novel...

07 August 2017 5,195 5 View

What makes the base catalyst reacts faster than acid catalyst during trans-estrification ?

Normally, the base catalyst complete its reactions within 1 hour where as the acid catalyst tends to finish within 2 hours during transesterification. What mechanism makes the base catalysts react...

05 June 2017 1,146 0 View

Which method is good for doping among this two methods ? 1. wet impregnation and 2. Hydrothermal or solvothermal process.

I'm trying to impregnate the nanoparticles in micron size powder. Firstly I was trying with wet impregnation method. I guess the proper doping is not happening. Will hydrothermal or solvothermal...

05 June 2017 3,867 0 View

Why does the magnetic property is losing while keeping the sample (Fe3O4) for calcination 500-900 degree Celcius?

i have synthesised magnetic material Fe3O4 by co-ppt method. Before calcination, the magnetic property was showing but after calcination above 500 degree C , the magnetic property is losing....

01 February 2017 5,426 6 View

Can i get the top rated journals list with high impact factor from nano catalyst for the biodiesel transestrification process ?

Researcher working on catalyst for transesterification of biodiesel please suggest me the top rated journal with high impact factor to be published.

31 December 2016 6,460 1 View

What is the best method to coat Cerium Zirconium oxide on copper tube ?

I'm trying to coat the Cerium Zirconium oxide NPs on copper tube. I have tried brush coating and dipped coating but its not sticking on the copper tube. Any suggestion for better coating, Please...

31 December 2016 9,144 1 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Handling Missing Data and Building a Predictive Model with Incomplete Information ?

I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...

10 August 2024 4,005 2 View

Is it possible to use the Fused Deposition Modeling (FDM) to additively manufacture interconnected porous structure generation of >100-200 micrometer?

Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...

09 August 2024 7,892 0 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

How to generate a citation of my paper from ResearchGate?

How we can cite the papers from ResearchGate. I am trying to create citations for this article, Quantum Machine Learning Algorithms for Optimization Problems: Theory, Implementation, and...

08 August 2024 6,690 3 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

Can you suggest reliable sources defining "3D mesh" and "3D city models"?

Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...

06 August 2024 9,986 2 View

How to get links for copyrights for papers?

how to get links for copyrights for papers?

06 August 2024 7,410 1 View

How to determine positive-stained cells in FACS? Use isotype or unstained control?

To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...

06 August 2024 6,728 6 View