Dear All.
I hope you are doing well, I have a problem handling this blade geometry, I am trying to perform analysis on this blade but I could not use the APDL, it shutdown when I start meshing directly, so I tried to export it via IGES so I can use the workbench but unfortunately the geometry is not complete as shown in the picture. I found many problem reconstructing it since a lot of details are missed and I am not the owner of the original design.
Is there any solution?!!!
When you create new project in workbench and load a new geometry, before you open it in ANSYS mechanical (ie.) you could try just "Edit geometry in space claim", and after SpaceClaim start, just turn it off by clicking X. It works for me sometimes when geometry is faulty.
Or you could try exporting in some other formats.
Emir Nezirić Hello, Thanks for the feedback. I tried it and it works thanks for your advice but now I am having this Problem:
"The model dimensions in the solver unit system were determined to be very large. This may lead to numerical accuracy issues. Check results carefully."
I afraid that this is affecting all the results I am getting so please advice
- Badges
- Science topic