Experimental Design: How deal with pseudreplicates with immunological and clinical-chemical paramaeters?

Hello everybody, I am investigating the influence of a toxinon various clinical-chemical and haematological parameters in fish. I have three treatments (control, low dose, high dose) in my...

24 February 2021 1,243 1 View

How do I make nano-sized particles of Polyethylene?

I am attempting to make particles in the range of 50-500 nm from Low density polyethylene. My current protocol is to dissolve 0.1 g of LDPE in xylene at 100 C, then drip the resultant solution...

08 November 2020 7,764 1 View

How to compare percentages between two samples of different sizes in SPSS?

Dear all, I want to compare the percentage of "proportion of time in a specific arrhythmia" between two independent groups of different sizes (group A - 16 patients and group B - 61 patients)....

20 August 2018 7,933 3 View

How to inactivate biotin-streptavidin interaction for release of dsDNA?

05 February 2017 1,503 1 View

Is lambda phage DNA expressed in eukaryotic cells?

28 November 2015 1,525 3 View

Is anyone familiar with waters 501 HPLC solvent compatibility?

I have an old "Waters 501 HPLC Pump" - I wanted to know what solvents this system is compatible with? I don't want to use it for LC, I want to use it as a pump for some organic chemistry flow...

06 April 2015 7,325 5 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to upload pdf of my articles published?

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Would adding books published in Lambert Publishers increase my RG impact?

There are some books published in LAP. Shall I add it to the RG?

02 March 2021 2,753 1 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Is Journal of Agricultural Research a predator?

it is published by Juniper

28 February 2021 354 4 View

How can I publish a manuscript in free or low cost journal with good H-Index?

Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...

28 February 2021 7,800 6 View

Which software is better to write systematic review paper?

We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...

27 February 2021 6,296 1 View

Can I put a figure that was drawn by Bio-Render in publication paper?

I want to publish paper in journal but I have figures which have drawn with bio-renders, can I put them in the paper or which other software I can use to draw them?

27 February 2021 8,179 1 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

Can anyone please help me in processing SAR SLC data to generate interferogram using SNAP?

I have two scenes of the study area, one top and the other bottom. As per the tutorials and papers published, the step include coregistering the master sand slave images. However, when i try to...

24 February 2021 6,372 1 View