Can someone send me a radial turbine rotor geometry for analysis in cfx ?

16 May 2021 1 4K Report

I need the geometry with experimental data for validation, I really need it my pc had a virus and I lost all my work and in deadline to deliver it to school it will be a real help if anyone can send me this in my email

[email protected]

I would be very grateful.

Salameh Barhoom

Dear colleaque: My suggestion is to compare the simulated flow around a turbinr uding A NSYS CFX and open FOAM. Both software used K_SST Turblence..

Ref.www.Researchgate.net>publications

Badges
Science topic

How vaccines of covid 19 work?

Millions ask how vaccines of covid 19 be successful and safe, its here to explain generally how vaccine of pfizer work ,mRNA vaccines teach our cells how to make a protein that will trigger an...

28 February 2021 2,723 4 View

Problem with shRNA transfection. Why are only two plates getting contaminated instead of all?

I transfected my LNCaP-WT cells with 3 shRNA plus their NTC two weeks ago and split two puromycin selected cell plates on Friday last week(Feb 26). I checked for GFP in the cells, and they all...

28 February 2021 4,949 3 View

Best plasmid could be used as a standard curve for AAV titration?

I have been trying to have a good AAV titration for my production and I have tried different plasmids to set up as a standard curve but each one behaves differently. i am trying to use ITR for...

23 February 2021 5,167 3 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

How to control the variants vof covid 19 in second and third waves?

A the world find means to control covid 19 by vaccination ,new variants came to spread and make the world in fear and danger, to understand the conduct of these variants, es constantly change...

21 February 2021 3,080 6 View

Surprisingly low antibody titers against SASRS-COV-2 RBD in hamsters compared to mice?

21 February 2021 6,958 2 View

Will SARS-CoV-2 Spike be broken into S1 and S2 by denaturing conditions?

Hello, I am performing a western blot of my SARS-CoV-2 Spike-pseudotyped lentiviral particles. I denature my virus by adding concentrated virus to 2X Laemmli buffer at 1:1, then boiling for...

17 February 2021 4,844 4 View

How to combine two geometries in LAMMPS ?

I am trying to simulate contact angle of water on a quartz slab using LAMMPS. I have created and equilibriated the quartz slab and the water cluster separately. Now I want to create a composite...

17 February 2021 5,884 2 View

How to calculate the TCID50 when the highest CPE is 50% or less?

I am doing TCID50 to measure progeny virus and some treatments protected the cells in a way that the highest CPE observed is 50% or less. How should I do the titre calculation in that case? Thank you!

16 February 2021 8,768 1 View

How to estimate/know plant virus concentration to make a standard curve in ELISA after serial dilution?

Hello, I am trying to know tomato virus titer/concentration in samples and I will perform serial dilution of the positive control. I wanted to ask How to estimate/know plant virus concentration to...

13 February 2021 6,534 4 View