Can graphene adhere to glass? The electrode being used is Graphene.
Cr can attach to glass. If graphene cannot attach to glass, maybe evaporate a little bit of Cr (10~20 nm) to seat-belt it on the glass?
Can i perform Verification and validation checks on datasets like AndroPRAguard, Drebin(contain malware and benign mobile apps)? Verification and validation checks for data: Verification of...
31 March 2020 8,600 1 View
I have used SEM with AMOS for my data for hypothesis testing and the model parameters came out good. I wanted to conduct a multigroup analysis with the same sample by categorizing them into two...
16 December 2019 7,453 3 View
I am working on a small protein that is a part of a polyprotein. All attempts to make an antibody against it have failed. I have been trying to tag the protein sequence with several different...
20 February 2014 2,118 6 View
I want to use them as cathodes in OPV.
18 October 2013 315 3 View
What is the take of modern science on ancient sciences like Vedas, Puranas, Yoga, Ayurveda etc? Do they qualify as science? Why and Why not? Has western colonisation of the world influenced the...
01 January 1970 4,213 28 View
In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...
01 March 2021 2,207 3 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
24 February 2021 2,362 5 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...
23 February 2021 4,155 4 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...
22 February 2021 5,324 3 View
I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?
21 February 2021 2,141 3 View
I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.
21 February 2021 5,465 4 View
I have done Uv-vis characterisation of my thin film and have received absorbance and transmittance data. Now I want to calculate the absorption coefficient but I dont know the thickness of my...
21 February 2021 7,148 8 View