An allotropic form of carbon that is used in pencils, as a lubricant, and in matches and explosives. It is obtained by mining and its dust can... | Contact experts in Graphite to get answers
2,622 views 654 posts
Questions related to Graphite
JCPDS file for XRD analysis
12 August 2023 9,512 1 View
Mark the solidus and liquidus points on the DSC graph
10 August 2023 3,188 1 View
Considering that the refractive index of glass (SLS) depends on density and polarizability. 1- Which of these two factors has a greater effect on the refractive index? 2- Which of the compounds of...
07 August 2023 2,321 1 View
What acid is better to use to remove titanium oxide from silica in the acid washing process?
06 August 2023 8,382 5 View
I am trying to deposit some magneto impedance thin film sandwich structures and I was wondering if I can skip the photolithography step and make use of Kapton tape instead. Let me know if anyone...
03 August 2023 9,431 2 View
we want to know the minimum acceptable yield .
29 July 2023 6,360 1 View
Anyone have any idea regarding if addition of metal powders in pdot enhance there electrical conductivity? I see some research papers with insitu reduction of Nanoparticles. But would just...
14 July 2023 9,529 1 View
Hello all, My question pertains to the rationale behind selecting the lower and upper voltage limits for the electrochemical window in lithium-ion batteries, regardless of the active material...
10 July 2023 1,747 1 View
I am synthesizing MOF with alkaline earth metal (AEMOFs), using alkaline earth based on carbonate with organic linker BDC (terephthalic acid) with solvent water and DMF. After the synthesis, I...
01 July 2023 3,765 2 View
I have some CVD graphene on copper that I need to cut into circular discs. I can obviously do it using scissors but it wouldn't be super precise and can damage the film in surrounding areas. Would...
21 June 2023 3,479 4 View
After the semi dry transfer for 2 hour, I saw the blot after 5 minutes started to look too dry(Image attached). I activated the membrane with methanol and then soaked in transfer buffer. Marker...
15 June 2023 6,731 1 View
for detetmining charge mobility i need the values of D(diffusion co-efficent). To detetmind D by using D=1/2d2k how to determind d (spece between two molecule) and k(charge hopping rate).
14 June 2023 4,158 0 View
Using origin software, plot the graph showing capacitive and diffusive contribution from CV curve.
26 May 2023 5,958 0 View
I want to design a silicon metasurface (SIO2 substrate and single Si nanofin) to operate in Near Infrared Region in CST. What parameters (values) i need to accurately model Si/SiO2?
23 May 2023 8,599 2 View
I need them for my undergraduate thesis. Also, if you know where I can get the ICDD data cards for these; (01-076-0147), (01-071-0467), (01-078-5636) and (01-079-6670) please let me know. Thank...
13 May 2023 4,784 0 View
a. +4 is the place of co2 molecule in front of the graphene.
25 April 2023 3,736 3 View
I am trying to deposit GMR stacks of Ta(5)/IrMn(8)/CoFe(2.5)/Cu(2.2)/CoFe(2)/NiFe(2)/Ta(5) (in nm). I have only 2 target spots available. I was wondering if I can sputter in different steps...
12 April 2023 2,992 3 View
We are trying to fabricate free standing thin films (~2um) using SU86002. Since SU86000 is not extensively used in literature, we initially started off with the data sheet parameters and found...
10 April 2023 5,355 1 View
Ref. Structural Determination and Nonlinear Optical Properties of New 1T‴-Type MoS2 Compound. J. Am. Chem. Soc. 2019, 141, 790−793
02 April 2023 8,212 0 View
if we are using a substrate for holding the CNTs during upward sputtering since CNTs are in powder form, which Substrate can be used without affecting the purity of CNTs and how to separate metal...
29 March 2023 8,133 5 View
The prepared ink was drop-casted on NF of equal volume. Different mass loadings observed on NF which is due to the density variations. Is there any calculation or experimental method to normalize...
28 March 2023 2,111 4 View
I know we can create Gmr (giant magnetoresistance) films using PVD techniques but I was wondering if it would be possible to do so using something non-traditional let's say like mechanical...
22 March 2023 6,601 1 View
how to do modling and create code in MATLAB?
15 March 2023 5,626 3 View
What are the key steps involved in interpreting an FTIR analysis, and how can I go about learning to identify specific functional groups and compounds in the spectrum?
13 March 2023 280 2 View