Dear all,
For troubleshooting of this error, what can I do?
--------------------------------------------------
Error in job Job-1: *DENSITY REQUIRES THE USE OF *USER MATERIAL, *ELASTIC, *EOS, *HYPERELASTIC, *ANISOTROPIC HYPERELASTIC, *HYPERFOAM, *LOW DENSITY FOAM OR *FABRIC
Error in job Job-1: THE *VISCOSITY OPTION MUST BE USED IN COMBINATION WITH THE *EOS OPTION
Error in job Job-1: 139469 elements are missing elastic property reference. The elements have been identified in element set ErrElemMissingElasticPropRef.
Job Job-1: Analysis Input File Processor aborted due to errors.
Error in job Job-1: Analysis Input File Processor exited with an error.
Job Job-1 aborted due to errors.
most probably , you haven't assigned a young modulus and poisson ratio in your model.
These type of error are usual in ABAQUS.
At first, make sure that all required properties of materials are defined. After that, edit the defined sections ( I myself recommend you to delete and redefine sections). Finally, assign the sections to materials and check your mesh module ( if it is required or you can remsh the whole model).
It should work ;)
I'm trying to simulate micro structures with pores. If I give 0 as E modulus for the pore I get this error. If this is your case, you can try assigning a very low E module to the air and take care if it would interfere in your results.
- Badges
- Science topic