Can I separate monomers and oligomers from Polymethyl acrylate which was produced via convensional heating method?

Anupama Marulichikandiyil @Anupama-Marulichikandiyil

17 October 2022 1 146 Report

We dissolve PMA in acetone and precipitate in ethanol?Is it correct method?Instead of ethanol can I use methanol?

Theoritically it is easy to separate monomers and oligomers from the polymer product just by selecting a suitable solvent. But practically it is somewhat easy for monomers and difficult for oligomers. However, it could be made easy by employing temperature coefficient along with a suitable solvent.

Badges
Science topic

More Anupama Marulichikandiyil's questions See All

Von mises stress not showing for (key in label ) node,after selecting probe values?

The job runs(shows von mises stress 75% to the highest 363.9 Mpa) upto the yield strength (361 Mpa) although it has a ultimate strength (469.29 Mpa)specified. Whenever i try to take some data of...

05 April 2024 6,614 0 View

Trying to draw a pipe bend angle other than 90 degree in abaqus 2017 .How can it be done ?

There is no video on youtube that is helping me regarding this issue.Which of following icon in the attached screenshot can help me with it ?

01 April 2024 9,418 0 View

In abaqus 2017 ,my simulation job runs but it is not showing the 75% average von mises stress for any kind of time frame.Can anyone help with it ?

1.Fixed boundary condition at both end of the pipe elbow. 2.Pressure applied is 30 Mpa. 3.Hex ,sweep mesh applied.

18 March 2024 5,935 2 View

Could anyone recommend materials that have been successfully used to mimic the mechanical properties of bone and neural tissue scaffold?

Hello ResearchGate Community, I am currently working on my final year undergraduate project, which involves the compression testing of tissue scaffolds, specifically focusing on neural and bone...

02 March 2024 4,600 1 View

Optical and acoustic mode in FMR ?

We have observed in literature regarding the optical mode and acoustic mode in FMR spectra. How to identify which one is acoustic and which one is optical? Kindly clarify.

07 June 2023 3,986 3 View

Other than extract method and seeding cells on scaffolds, is there any other methods that can be followed to perform MTT assay?

I have been working with a ceramic based scaffold, and it is to be determined for cell viability, for which I have chosen MTT assay. Although I have tried seeding cells onto the scaffold or taking...

19 January 2023 1,565 4 View

Sparse Matrix Multiplication can be used in both distributed system as well as parallel system?

could anyone clarify that whether can we use Sparse matrix multiplication in parallel distributed system or is it restricted only to Distributed system? If so pls help me with algorithm

02 July 2022 8,619 2 View

Facing problem in UV curing. Why is UV curing not happening even at the desired concentration and wavelength?

Good day researchers! I have been trying to methacrylate and proceed further by UV curing. As per literature, 0.5-1% (w/v) 2-hydroxy-1-[4-(2- hydroxyethoxy)phenyl]-2-methyl-1-propanone (Irgacure...

11 December 2021 7,242 2 View

Hello everyone , hope you all are doing well. can anyone please suggest me a protocol to make a thiol containing myatansinoid to a thiol free ?

I want to make a thiol containing myatansinoid or DM1 compound into thiol free for conjugation process without diminishing it's cytotoxic potential.

14 November 2021 340 2 View

How to prepare 50 mM potassium phosphate (KPi)/50 mM sodium chloride (NaCl)/2 mM ethylenediaminetetraacetic acid (EDTA), pH 6.5 buffer solution?

Can anyone guide me how could I prepare this buffer? Should I first prepare 50mM potassium phosphate then 2 mM ethylenediaminetetraacetic acid (EDTA) .Then I should mix them and pH should...

13 October 2021 1,647 1 View

For the moringa oleifera extract using ethanol as the solvent,what is the alternative method to concentrate the extract other than rotary evaporation?

99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified

31 July 2024 5,112 4 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

Aqua regia not heating up?

I used Aqua regia to clean Au nanoparticles in the used glassware. But for some reasons, it is not heating up upon mixing. The color did change from no color to light orange. The Au NPs on the...

25 July 2024 4,389 0 View

Comparison of Methanol and ethanol treatment on collagen based scaffolds?

Kindly share a research paper that explains the effect of Methanol and ethanol treatment on collagen based scaffolds. How it increases porosity and swelling. Kindly help me find a paper. Thank you

24 July 2024 3,937 0 View

What is the heating temperature that I can use to deactivate enzymes in bacterial extract exopolysaccharide without loss of the bioactivity of EPS?

What is the heating temperature that I can use to deactivate enzymes in bacterial extract exopolysaccharide without loss of the bioactivity of EPS? Hi I am trying to make the purification (by TCA...

22 July 2024 5,333 6 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

What is wrong with my input file?

im studing gaussian 16 with reading paper about I-131 Metaiodobenzylguanidine in the paper "In a similar vein, nuclear magnetic resonance shielding values were investigated using the widely...

16 July 2024 6,040 4 View

I need to know the required time for VDF heating with water for 50-80°C for PVDF Polymerization in ?

i need to know the required time

15 July 2024 4,796 2 View

Why my plant protein cannot resolubilize after TCA/Acetone extraction?

I am extracting proteins from plant samples and am currently attempting to use the TCA/Acetone extraction method. I am having trouble resolubilizing my sample after drying the pellet. I collected...

15 July 2024 9,025 3 View

I want to plot calibration curve of pure mirtazapine powder using HPLC. Can someone please suggest a method without HPLC buffer as a mobile phase?

I am searching for HPLC method to estimate Mirtazapine but i want to avoid HPLC-buffers as a mobile phase component. So, I am looking for alternative HPLC-solvent (acetonitrile, methanol etc.)...

14 July 2024 1,493 3 View