Can anyone help me with the link of a book ?

Can anyone help me with the link of a book titled, "Computational Analysis of Multiphase Flow in a Helical Water-oil Separator Using CFD. Texas A&M" Authored by: Vijay Lakshmi .E

07 August 2018 9,515 0 View

Does increasing the tube length and decreasing the tube diameter, decreases the particles deposition ?

I have a fluid with few particles mixed. The fluid and the particles are flowing in a tube. I could see the particles are getting deposited on the tube surface. Now, i wish to decrease the...

02 March 2018 9,128 3 View

How can we induce shear on the wall surface of heat exchangers ?

Are there any ways to induce small amount of shear stress on the heat exchanger walls ? It can be done by increasing the velocity of the fluid and by increasing the surface roughness of the wall....

02 March 2017 5,075 7 View

UDF error :Error: receive a fatal signal (Segmentation fault)

31 December 2016 3,924 1 View

Does porous-spongy like particles have shape factor ? If yes, may i know the range ? or calculation procedure ?

11 December 2016 5,265 2 View

What is the current advanced research in the field of oil and gas for performing computational simulations?

As oil and gas field is one of emerging field all over the globe,Seeking to know the current computational research which is much into interest in the field of oil and gas

09 October 2013 2,490 2 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Arena simulation - how do i model the following model in ARENA (see description) (new to ARENA)?

Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...

02 March 2021 2,431 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View