Can anyone guide how to use the minitab software for optimization studies ?

More Prachi Bhatia's questions See All

In PRIMER, is it possible to downweight certain taxa in multivariate community datasets to reflect uncertainty around identification??

I have a dataset with about 80 different species. As usual, some species are very easy to identify with certainty whereas others are more difficult, which means that I am less certain of my...

03 March 2021 8,066 4 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

Gel electrophoresis result for total RNA samples, 1.5 Agarose gel was used, How to improve the integrity of RNA?

Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue

02 March 2021 5,433 5 View

How to grow E.coli on the low salt LB agar plate with 50 or 100ug/ml of Blasticidin?

Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...

01 March 2021 2,027 2 View

OpenBCI eeg--has anyone used them?

I'm looking to try out an off-the-shelf EEG set for some exploratory work. Curious if anyone has used the OpenBCI, and how much set-up work is required. I've heard they are more difficult to get...

01 March 2021 4,128 3 View

How to remove DCU and HOBT from my reaction?

I am doing a acid and a chiral amino alcohol reaction using DCC and HOBT in DCM or THF? Can anyone suggest me how to remove DCU and HOBT from a reaction mixture??

28 February 2021 2,153 1 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

B-mercaptoethanol (BME) protocol?

Hi everybody, I have been running a multiplex IHC which allow me to stain the same tissue with different markers (Primary Ab + Secondary conjugated Ab) (AF487, AF555, AF647). Since I would like to...

27 February 2021 5,028 2 View

What is the suitable range of Sulfur content and Viscosity of Heavy fluid Oil that used in Kiln?

What is the disadvantages of high sulfur content to the ceramic burning process? and what is the effect of outranged viscosity?

24 February 2021 8,219 2 View

Does anyone know a free large dataset from smart factory with data collected from IoT objects that I can use in academic research?

I am working on the integration of the Internet of Things into business processes. To evaluate my method, I need a large dataset with data collected from different kinds of objects. Thank you!

08 December 2020 7,338 4 View

SAS code for a "Split-plot in time" (based on CRD design)?

Dear all, I want to analyze a factorial split-plot in time using SAS. Factorial Experiment using Completely Randomized Design (CRD); Factor A: treatments (a1-a4) Factor B: harvest time,...

28 October 2020 3,515 4 View

How can I calculate the Orthogonal Design with SPSS efficiency?

Hi, I have done a research and to developed my conjoint profiles, I used SPSS Orthogonal Design. One of the reviewers came back to us and questioned the efficiency of the Orthogonal design....

14 October 2020 4,566 2 View

(Statistics with JMP) What is the correct way to analyze a 3way full factorial experiment design with repeated measurements?

Hi there. I'm not a statistician, so just doing my best to understand and describe my challenges here, so I hope you'll bear with me. I'm currently working on a project in mice where I have 3...

13 October 2020 4,287 3 View

Factorial ANOVA Assumptions Violations...What to do next?

Hello! I am conducting a 2-way factorial ANOVA. Normality was violated (Shapiro-Wilk Sig.=.000) and homogeneity was also violated (Levene's Sig.< 0.05). I understand that here isn't a common...

24 July 2020 9,304 3 View

Insignificant main effects, but signiciant interaction in 4 X 2 X 5 three-way factorial ANOVA?

I ran a 4 X 2 X 5 three-way factorial ANOVA to explore any viable variance in EI (Emotional intelligence) across the participants' age, gender, and YTEx (years of teaching experience), and found...

21 July 2020 5,654 4 View

What does it mean to have non significant results in 2x 2 factorial anova?

Hi there, I have conducted a 2x2 factorial anova and was surprised to see non significant results for interaction as well as for the first main effect and second main effect. How do I interpret...

20 July 2020 648 1 View

What statistical test should I run on factorial but non-parametric data?

Hi, I am completing an assignment on factorial ANOVAs, however my data is not normally distributed and does not have homogeneity of variance, thus not meeting the ANOVA assumptions. This uses a...

13 April 2020 3,349 10 View

What is DPL command to find maximum value in a graph drawn in Digsilent Power Factory?

what is DPL command to find maximum value in a graph drawn in Digsilent Power Factory?

28 March 2020 5,674 3 View

Mixed Factorial Anova Post Hoc Tests?

In a 2 by 2 Mixed Factorial Anova, how would you go about conducting post hoc tests when you only have two groups. Would you conduct an independent samples t-test after the Anova to explore...

28 February 2020 9,970 4 View

Alexander Ohnemus

In order to find any true answer, a system must be offer skin in the game.

Whenever aiming for rigor in academia, the culprit for difficulty may be excessive centralization. HEURISTIC: the more centralized a structure, often the more fragile. To find more academic freedom and rigor, academic institutions must decentralize: Ohnemus , Alexander . "A Girardian Case for PhDs by Publication." ResearchGate.net . www.researchgate.net/publication/373639875_A_Girardian_Case_for_PhDs_by_Publication. Accessed 5 Sep. 2023.

Balasri Prasad Kamarapu

https://www.minitab.com/en-us/solutions/industry/academic/teaching-resources/

Prachi Bhatia