3T3-L1 cells are growing slow in The DMEM/10%FBS media; any reason for that ?

3T3-L1 adipocytes

31 December 2018 3,180 4 View

Can any one give any simple protocol for annexin v pi staining for cell line flow cytometry analysis with or with out cell fixation ?

annexin v staining protocol adherent cells with cell fixation for flow flow cytometry

09 October 2017 393 2 View

Any place to Buy Hep3B cell line other than NCCS pune In India ?

Hep3B cell line

07 August 2017 6,272 0 View

Hello Dear Scientists Please explain use of Chang liver cell line why we use? can we use for anticancer activity ?

Chang liver cell line why we use? can we use for anticancer activity ?

01 February 2017 763 0 View

Please do suggest any Liver control cell line For liver cancer ?

01 February 2017 2,201 5 View

Can any body tell about standard drug concentration for Cytotoxicity assay ?

07 August 2016 2,775 2 View

Can i use "chang liver" cell line as control cell line for cancer cell line?

07 August 2016 1,674 0 View

Dear Friends Please help me to do autodocking in Mac OS, what are the sofware need and any installation and working procedure for that?

autodocking in Mac OS, Softwares in autodocking

06 July 2016 6,466 0 View

How to do dapi staining for Adherent cells? its same to PI staining for cell cycle assay please clarify ?

06 July 2016 5,619 4 View

Can i use 5-fluorouracil as a control Drug for liver cancer cell lines ?

control Drug for liver cancer cell lines

06 July 2016 1,201 2 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Should we change media after1st 6hrs after plating HUVEC bought from INVITROGEN?it's not recomended by invitrogen.Will DMSO present in stock matter?

We have HUVEC bought from Invitrogen. Cat no -C-003-5c. while first plating the cells we have bought the protocol suggests not to centrifuge the cell with media to remove the DMSO. Should we...

02 March 2021 3,713 2 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

How does an antibody have full intact antibody + half antibody?

Hello, I was just wondering how does a antibody have full intact antibody + half antibody? Is it because of the drug conjugation?

28 February 2021 1,577 1 View

RIA. How to measure?

When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...

28 February 2021 2,133 3 View

Bought HUVEC from Invitrgen.need to revive it.expected it is cryofreezed in DMSO.Do I need to remove the DMSO for plating the cell for the 1st time?

After I cryofreeze the cell do I need to remove the DMSO for culturing the cell for next passages .

28 February 2021 7,738 3 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

What is the most suitable resuspension buffer for TCA/acetone precipitated protein?

I need to extract protein from fermented carbon sources for Bradford assay. Most researchers experiencing insolubility of pellet in resuspension buffer. Please assist me to select most suitable...

26 February 2021 7,129 3 View

How do I choose contrasts in SPM8?

I am learning how to use SPM for PET and PET-MR analysis, but I haven't found any great resources that explain how contrasts work. I have a series of PET images where our hypothesis argues that...

24 February 2021 1,534 2 View