05 May 2017 1 9K Report

Acids & Bases Buffers Deprotonation 

More Satadru Chakrabarty's questions See All
Different Raman spectra of graphene like quantum dots?

The characteristic raman spectra that I've obtained for graphene like quantum dots shows a kink at about 1450 cm-1, this is different from the reported literature. What can be the posible reason...

01 February 2020 3,135 3 View

How can I index XRD peaks of a graphite like sample?

I've a nano-scaled graphite like material, the XRD pattern is showing some peaks which are not matching with any of the reported literature. For example usually a broad peak is seen around 21...

01 February 2020 6,479 2 View

What can be the perfect GC-MS operating conditions for acetonitrile?

I have to analyse the change in composition of acetonitrile after being reacted mechanically at different time intervals, hence I'm planning to undertake a GC-MS of the samples. Can anyone suggest...

05 June 2019 9,342 8 View

What is a Solid State Metathetic Reaction?

What kind of synthesis is this SSM route useful for?

03 April 2018 10,226 2 View

Can retention time for a particular compound change when detected at various wavelengths?

I'm using a PDA detector HPLC unit, I was wondering whether it is possible that the retention time can change for a particular compound when the detector is set at a different wavelength, all...

11 December 2017 5,613 6 View

What can be the plausible reason for increase in the area of a peak in HPLC spectrum, even when the reaction is to degrade the compound?

I'm withdrawing samples after a 15 minute interval for 90 minutes. Hence, the 90th minute sample is to show the highest amount of degradation or the least peak area, but it shows the highest, this...

10 November 2017 6,053 7 View

What is the JCPDS card number for potassium ferrioxalate trihydrate crystals?

How to identify crystalline phase data from the XRD data of the said crystals

08 September 2017 591 2 View

Why is the lambda max of dibenzothiophene chosen as 275-284nm and not 230-240nm?

In most research papers the wavelength chosen for DBT detection is 284nm, but according to the NIST data the maximum absorbance occurs around 230-240nm. Can anyone explain why it is...

07 August 2017 4,252 4 View

What could be the HPLC conditions for thianaphthene/benzothiophene?

How do I choose the best conditions for this sort of HPLC? 

07 August 2017 8,424 4 View

Which is the better analytical software Modde Pro or Design expert? Why?

statistical analysis, software, data analysis designing experiments 

07 August 2017 5,929 4 View

Similar questions and discussions
What is the reason for current dropping in OER , LSV curve?

I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...

10 August 2024 3,629 1 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

Determining the worth of a point improvement in Hamilton Depression Scale?

Dear readers, Thanks for your attention. I am wondering about the health economic problem of quantifying the value of interventions which a) prevent, b) improve symptom profile and c) ultimately...

05 August 2024 3,246 1 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

Conjugation of PEG-Amine to an Amino Acid Using EDC?

I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...

31 July 2024 2,033 1 View

Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?

Hi, researchers, Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?

29 July 2024 4,570 0 View

EDTA buffer solution?

Hello everyone! How can i prepare EDTA buffer solution (pH 8.2) to determine GSH levels? Thank you in advance.

29 July 2024 4,374 1 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close