Dear all, What is the best protocol to isolate lymphocytes in skin tissue?

We want to obtain infiltrate lymphocytes in skin after Imiquimod (Aldara) treatment for FACs analysis. Some works used Liberase Blendzyme plus DNase I (Roche) and others used Dispase +...

01 February 2016 8,053 3 View

Dear all, did anyone analyzed ALCAM expression in B16 melanoma by FACs?

I'm working in the interaction ALCAM-ALCAM in metastasis models. I wondered if anyone checked the basal expression of ALCAM in B16F0 and/or B16F10. I have observed different results of ALCAM level...

01 February 2016 9,692 1 View

Did anyone tested the immunosuppressive function of Treg by IL-35 release?

31 December 2015 3,869 0 View

How long can "knockout B cell-deficient mice" survive in a conventional room?

I wonder how many time the knockout B cell-deficient mice have a normal life when change the habitat SPF to conventional room.Thank you so much for your reply!

07 August 2015 5,303 4 View

Does anyone know what is the cheaper kit ELISPOT of IFN-gamma (mouse) in the market?

08 September 2014 8,628 3 View

Does anybody know if in intracellular staining for study of IL-1 cytokine it is necessary to previously incubate the samples with GolgiStop?

For cytometry analysis. Thanks!

07 August 2014 6,527 5 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

Logistical regression using SPSS for a dichotomous dependent variable, with an independent variable of 1, 2, 5 and 10 seconds?

I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...

03 March 2021 9,692 2 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Have someone successfully used the ER alpha (Santa Cruz sc-8002) antibody in immunostaining ?

Santa Cruz now recommends this new antibody (F-10) but I can't find a publication using this reference. I'm working on human et non human primate hypothalamus and so far, it doesn't work. Is...

02 March 2021 10,003 2 View

Ideas for Phd's Thesis on pricing (Marketing)?

Hi everyone, I'm studying Marketing and I would like to write my PhD thesis on the topic of pricing. Any specific ideas?

02 March 2021 9,706 5 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Does anyone know an alternative product for cardiac Troponin T antibody for Immunofluorescence (Thermo # MA512960)?

We have been using Thermo Fisher anti-cardiac Troponin T antibody for immunofluorescence staining in FFPE mouse heart sections but it was recently discontinued. The literature shows it to be the...

01 March 2021 4,937 1 View

Is it possible for two human neuronal cell lines to have different gene sequence for the same protein?

I am looking at the ATP1A2 (Sodium/Potassium ATPase alpha subunit 2) in two human neuronal cell lines. Expression levels of this protein seems to be almost equal when detected by one antibody....

01 March 2021 3,607 3 View

How to define tie constraint between rigid body and another part in dynamic explicit model of Abaqus?

Hi dear researchers I connected a rigid body into the part of my structure by tie constraint and then I added displacement to rigid body, in static general step every thing is fine and these two...

28 February 2021 3,442 2 View

How does an antibody have full intact antibody + half antibody?

Hello, I was just wondering how does a antibody have full intact antibody + half antibody? Is it because of the drug conjugation?

28 February 2021 1,577 1 View