Hye all;
Hope all of you doing fine today.. I want to ask related with meshing technique. First i manage to do all the mesh using hexa mesh and get the good quality mesh value which Minimum Orthogonal Quality is >0.1, then i need to study the combination of tetra and hexa mesh.Using same equipment then i change the hexa part as you can see in the picture with tetra mesh. Unfortunately, this time i cannot get the mesh quality of Minimum Orthogonal Quality >0.1. The value is to small. Any idea on any technique to combine this hexa and tetra mesh so i can get the good quality mesh value. I use ANSYS FLUENT software. Thanks in advance.
Dear Mrs. Rasep,
First of all, what is the purpose of combining the two types of elements?
It is obvious that each element type has its shape and suitable for a specific geometry model, so, it is expected to have less quality of mesh when you combine two different types of elements.
Thanks for your answer mr Ahmed Mahmood Abdullah Daabo ..actually i want to study the effect of final result when i do only HEXA meshing and when combine both TETRA and HEXA mesh.. for HEXA mesh only i get good quality value, unfortunately when i combine TETRA and HEXA, i don't get good quality value. Or this situation usually happen when combine both mesh?i mean get the bad quality mesh.Thanks for sharing your opinion. I really appreciated it.
- Badges
- Science topic