Hello
I have modelled RC beam in ANSYS apdl.
first create volume, then create keypoints & create a line joining that keypoints to make reinforcement.
I am working on thermal analysis, for that i am using solid 70 for concrete model which DOES NOT HAVE OR REQUIRE ANY REAL CONSTANT.
Now during mesh attributes when I assign solid 70 to material 1, it also asks for real constant.
solid 70 has no real constant
what is nthe solution of this problem
Dear Tanu,
I recommend you to have a look at this link:
https://www.mm.bme.hu/~gyebro/files/ans_help_v182/ans_elem/Hlp_E_SOLID70.html
I believe you are using an older version of ANSYS likely before 14.5. Check it by using a newer version of ANSYS. Even if it is asking to define it, then define the properties, I think you can define some properties there also.
- Badges
- Science topic