About apparent properties of a multilayered plate?

28 December 2024 0 1K Report

Hi,

Are there empirical models that link mechanical properties, such as Young's modulus, Poisson's ratio, and other characteristics, to the apparent properties of a multilayered plate, considering the intrinsic properties of the individual layers?

Badges
Science topic

Similar topics
Social Psychology
Attitude

More Hatem Ksibi's questions See All

I want to simulate an heterojunction solar cell using silvaco atlas and i need a help to do it?

i want to know how i can define the structure and regions correctly and make calculs to get a acceptable results like effeciency, Voc,Jsc, FF

01 February 2024 3,819 0 View

Does there be a drug-drug interaction between ceftriaxone and the proton pump inhibitors?

12 November 2023 9,128 8 View

Reaction of Nitric acid with Tricalcium phosphate How does it occur?

While phosphoric acid is generally considered more stable than nitric acid, nitric acid is known to react with tri-calcium phosphate (Ca₃(PO₄)₂) and dissolve it

23 June 2023 7,076 0 View

Time dependent concordance versus dynamic AUC?

Dear Colleagues I am trying to do survival analysis model for prediction. My main aim is discrimination I know that harrell c statistic is not time dependent and cannot tell across different...

14 February 2023 3,800 1 View

How to write a PHD's personal statement?

Hi, I am currently writing a Ph.D. personal statement. In general, I am aware of writing such a statement but the situation in my case is a little different. The university offers a funded Ph.D....

04 July 2021 2,742 4 View

Is the motor complications in Parkinson's disease are due to early use of L-Dopa or due to progression of the disease?

Is the motor complications in Parkinson's disease are due to early use of L-Dopa or due to progression of the disease

27 April 2021 9,060 6 View

How I can quantitatively measure porosity from SEM photos using softwares as imagej / Gwyddion/ .. others ?

We look to compare effects of several operational conditions on the texture of the deposit.

26 April 2021 883 3 View

How to write a PHD proposal for a predefined research?

Hello everyone, I am aiming to write a PHD proposal of 1000 words. The research is described by the supervisor. That means, research questions, aim, and instruments are well defined by the...

01 January 2021 6,700 7 View

What are the methods for determination the mechanical properties of URM buildings ?

Dear researchers i want to know the methods to determination te mechanical properties of URM hostiric buildings, and if is there theoretical methods with Safety factor

08 December 2020 8,641 7 View

How to calculate the capacity factor of a Hybrid Power plant?

Hi, I am analyzing the performance of hybrid concentrated Solar Power and Solar PV plant with a backup boiler operated by natural gas. The nominal nameplate of CSP is 100 MW and PV plant capacity...

18 October 2020 4,272 7 View

Is changing the medium during the experiment overestimate the results?

I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...

07 August 2024 2,283 2 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Can you recommend a 96-well plate for minimal cell adherence to the wells during phagocytosis experiments?

I have been performing short phagocytosis experiments using 96-round bottom, tissue culture treated, well plates (Falcon, 353077). I culture the cells with the phagocytic cargo for 2-4hrs, wash...

04 August 2024 5,228 4 View

Can't spin-orbit coupling(SOC) be included in optical properties calculation in CASTEP?

I am currently using CASTEP version 2020. When I want to run optical properties calculations with spin-orbit coupling(SOC), I encounter the following error in a pop-up window before the job gets...

02 August 2024 2,890 0 View

PBMC infection with virus?

In my study, I intend to infect PBMCs with SARS-CoV-2. After that, I will analyze NK cells by flow cytometry to see if their phenotype changes or if they show degranulation. After the infection, I...

01 August 2024 4,403 4 View

Found this object in the cell culture - do you have any suggestions what it might be?

Dear researchers, Today, we found this object in one of the wells of a 96wp culture plate. The plate contained MEC-1 cells and GelTrex. I am quite curious what this is (because it's not cells). Do...

01 August 2024 2,250 2 View

Publishing a checklist?

Does anybody know of entomological Journals without page charges that would publish an extensive checklist (Hong Kong Aculeates wasps) covering 350 species (of which more than half are new to Hong...

01 August 2024 6,134 2 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

Can you recommend provider Intermediate laboratory test for hydrocarbon, polyethylene & polypropylene?

Accredited laboratory of JV "Uz-Kor Gas Chemical" LLC (Uzbekistan) is looking for providers to conduct interlaboratory comparison tests on gas chromatographic analysis of hydrocarbons (component...

25 July 2024 8,108 0 View