When customizing the transmission ranges of nodes in tcl file, NS2 taking lowest transmission range in simulation. How can I change the value into highest (1000m or 2050m)?
#terminal output
num_nodes is set 4
INITIALIZE THE LIST xListHead
channel.cc:sendUp - Calc highestAntennaZ_ and distCST_
highestAntennaZ_ = 1.5, distCST_ = 250.0
SORTING LISTS ...DONE!
#in tcl file
#Higher range
Phy/WirelessPhy set CPThresh_ 10.0;
Phy/WirelessPhy set CSThresh_ 8.08e-14;#2050m
Phy/WirelessPhy set RXThresh_ 1.43e-12;#1000m
Phy/WirelessPhy set bandwidth_ 512kb;
Phy/WirelessPhy set Pt_ 0.28183815;
Phy/WirelessPhy set freq_ 2.4e+6;
Phy/WirelessPhy set L_ 1.0;
Antenna/OmniAntenna set X_ 0;
Antenna/OmniAntenna set Y_ 0;
Antenna/OmniAntenna set Z_ 1.5;
Antenna/OmniAntenna set Gt_ 1;
Antenna/OmniAntenna set Gr_ 1;
#lower range
Phy/WirelessPhy set CPThresh_ 10.0;
Phy/WirelessPhy set CSThresh_ 3.65e-10;#250m
Phy/WirelessPhy set RXThresh_ 1.43e-8;#100m
Phy/WirelessPhy set bandwidth_ 512kb;
Phy/WirelessPhy set Pt_ 0.28183815;
Phy/WirelessPhy set freq_ 2.4e+6;
Phy/WirelessPhy set L_ 1.0;
Antenna/OmniAntenna set X_ 0;
Antenna/OmniAntenna set Y_ 0;
Antenna/OmniAntenna set Z_ 1.5;
Antenna/OmniAntenna set Gt_ 1;
Antenna/OmniAntenna set Gr_ 1;
I used threshold.cc file to calculate appropriate values.
My work depend on change the data from software of nanobridge. Not change the distance
- Badges
- Science topic