19 June 2023 1 9K Report

For Methane dry reforming reaction (DRM), why do people try to avoid operating the reaction in thermodynamic equilibrium conversion?

Thank you!

More Xuan Pham's questions See All
Could someone please provide a list of journals that accept the application of methodologies in nature-based solutions?

I am looking for journals that admit the publication of results from applying the IUCN Standard for designing and monitoring Nature-based solutions. Many thanks for considering my request.

23 July 2024 6,444 2 View

How to use stress and displacement results from 1st stationary simulation as initial conditions for 2nd eigenfrequency simulation in COMSOL?

Dear All, I am trying to define the dispersion curves of a periodic unit cell in COMSOL Multiphysics with prescribed displacements. I am using two separate studies: - Study 1: Stationary, with...

13 July 2024 7,855 1 View

How to prepare materials before protein-peptide or protein-protein docking?

Hi all, I am conducting research on screening peptides (20-35 amino acids) with potential for treating dengue fever through protein-peptide docking methods. In the protein database, I found the...

10 July 2024 8,037 1 View

Why does my protein bind poorly to the Ni sepharose beads?

I am purifying RNAse E in E. coli (118 kDa). I cloned the rne coding sequence on pET28a with a His tag at the N-terminus. The protein overexpressed fine (see attached figures). The binding buffer...

24 June 2024 6,287 4 View

What does an increase in intensity mean in GIXRD?

When I examined the GIXRD data obtained recently, I observed that the sample treated with O2 plasma on the Cu surface deposited on Si chips showed increased intensity compared to the sample...

19 June 2024 6,900 5 View

Challenges in Stabilizing and Concentrating a Highly Unstable Acetyltransferase for Crystallization?

I am working on an acetyltransferase that is highly unstable. Its pI is 6.65, and its molecular weight is around 18 kDa. The protein elutes at 1M imidazole and begins to precipitate immediately...

19 June 2024 2,590 0 View

What could be the reason for the increase of baseline at low angles during GIXRD measurement?

I conducted GIXRD measurements after performing O2 plasma treatment on a Cu surface. It was observed that the baseline is significantly high at low angles (10-30 degrees). What could this...

18 June 2024 2,996 3 View

Vissim "lane closure" works well on "first" link, but not working on "second" link?

I attempted to model a temporary 'lane closure' due to an accident or work zone. Initially, I successfully closed Lane 1 on Link 1, and it worked as expected. However, when I tried to close Lane 1...

17 June 2024 2,070 0 View

Methods of O-methylation of amino acids without interfering the amine groups?

Hello guys. I have faced the problem of being in need of carboxyl-methylated amino acids. Amino acids I need are not available in the market so I need to synthesize them by myself. So thus I'm...

16 June 2024 9,920 3 View

How can I decide the variant I found segregating with a genetic condition is novel or known?

I found a variant segregating with a genetic condition, this variant is listed in ClinVar (with no clinical significance), gnomAD, etc. However, I could not find any publication reporting the...

10 June 2024 7,606 3 View

Similar questions and discussions
Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

In WECS : Gain values for conversion of PMSM rotor speed(rad/s) to p.u. input to wind turbine and Torque(pu) of WT to input of PMSM-Torque (Nm) ?

I am working on developing a MATLAB Simulink model of Wind turbine with PMSG followed by MPPT Boost converter. I have gone through so many literature and videos but I am not finding clear solution...

03 August 2024 888 1 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Is the black sediment consider as sand? If not, how can I filter it out?

Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...

30 July 2024 557 2 View

Where to start the Analytical model for Dry sliding wear of metal surface ?

I am doing research on wear mechanism of the additive manufactured metal parts under dry condition. Please share the reference to start the analytical modelling of the wear prediction.

29 July 2024 6,115 0 View

In passive sampling, can polymer-lipid partition coefficients be applied independent of environmental salinity?

For example, if low-density polyethylene (LDPE) is equilibrated with PCB contaminated marine and freshwater sediments, can LDPE-lipid partition coefficients be used to obtain equilibrium...

28 July 2024 263 1 View

How can one determine the conversion factor for a radiolabeled substrate to a radiolabeled product using slopes from linear regression equation?

I am preparing a radiolabeled product using a radiolabeled substrate. I have the cpm values for different dilutions of both my known substrate and unknown product ? How can one determine the...

27 July 2024 3,604 1 View

Issues with Malaria Coated Nitrocellulose Membrane Releasing Moisture?

Hello, I am currently working with Malaria Pf/Pan nitrocellulose membranes coated for malaria detection. After drying the coated membranes in an Incubator (overnight at 37°C), I've noticed that...

16 July 2024 7,937 1 View

How calculate the conversion alph from tga analysis?

I read it Convert the y-axis from mass loss to degree of conversion (100-x)%. What if tga analysis have residual char, for example at mass loss% 27% Is it the same eqation to get conversion...

15 July 2024 4,218 1 View

Franklin M. Fisher (1983) Disequilibrium Foundations of Equilibrium Economics. How is it estimated now? How is it related SMD results?

Fisher studied if there is an out-of-equilibrium process that rapidly converges to some equilibrium points. He claims that Hahn process has a Lyapounof function and therefore convergent to an...

15 July 2024 1,460 4 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close