T Heput
someone has some information about the optimization of the steel refining process in a spoon oven
31 December 2017 9,427 0 View
what is the best way for rolling steel process modelling?
11 December 2017 9,825 4 View
anybody have a study about a determination of sulphure in molten steel?
11 December 2017 5,951 1 View
someone has some information about the kinetics in the process of obtaining resulfurized steels?
11 December 2017 8,218 0 View
any way for use montecarlo methods in nonestacionary heat transfer?
10 November 2017 5,503 3 View
what do you think about the specimen creation in solidification of steel?
10 November 2017 3,786 0 View
someone can help me get some study related to the breakdown of chemical energy in steel furnaces for the production of steel
10 November 2017 9,020 0 View
how i can obtain any elastoplastic model in steel solidification?
10 November 2017 9,590 0 View
some model to optimize the amount of coating of copper electrical conductors"?
10 November 2017 8,418 0 View
what is the most way by studies in modelling of heat transfer in continuous casting steel ?
09 October 2017 606 2 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...
05 August 2024 3,665 0 View
I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...
03 August 2024 6,028 4 View
AI-driven technologies offer previously unheard-of capabilities to process enormous volumes of data, extract insightful knowledge and improve predictive models, according to the UN’s World...
31 July 2024 9,733 3 View
