VIF very high, but correlation is low and coefficient is significant. Which one whould I choose?

Hello. I have a question whether if my coefficients (statistically significant) would be valid when VIFs are really high. In my model, there are independent variables(IV), moderating variables...

26 February 2021 956 13 View

How to clean up TEM grid with plasma cleaner?

I need to clean the hydrocarbon contamination on the carbon substrate of TEM grid. However, I heard that substrate could be broken by the powerful plasma. My substrate is pure carbon, with ~3nm,...

23 February 2021 3,262 5 View

Sb2Te3 thin film annealing and damage(break)?

21 January 2021 9,642 2 View

When comparing two very similar surveys taken over time, but with different sample size, what would be the best way to approach this problem?

Hi, I'm currently analysing a survey for a university course design, and some guidance would be very much appreciated. The students who are enrolled in a (year-long) course were given a link to...

08 December 2020 6,624 9 View

When analysing survey using Likert scale, is it okay to use Friedman's test?

Hi, I'm currently analysing a survey for a university course design, and some guidance would be very much appreciated. The students who are enrolled in a course were given a link to participate...

06 December 2020 6,060 2 View

Which time-serie model is good when using concatenate data?

I would like to make a model using sequence datasets. As I've searched that , many LSTM, RNN tutorials use long-sequential data such as weather in 1950-2020. However, my datasets are short...

24 November 2020 808 3 View

Could you answer some basic questions on CRISPR-cas9?

Hi, I would like to ask simple some questions related to CRISPR-Cas9 that I could not understand by reading some basic articles on it. I am not in that scientific field so my questions might be...

21 October 2020 2,439 2 View

How can I design resin column for test?

I'm interested in the research field of ion exchange resin. I want design about resin column with acryl for test. How do you usually design the diameter and length of small columns for test? I...

13 October 2020 3,443 2 View

How do you check the locations of brain-implanted cannulas?

Hello. I implanted single cannulas bilaterally into the brains of mice to infuse drugs. After behavior tests, what would be the simplese way to validate if the cannulas are in the target areas?...

18 September 2020 8,457 3 View

Why this HPLC data show negative peak?

Lysine was dissolved in mobile phase and injected in HPLC but there are two peaks. One for positive at 2.1 min and another for negative at 2.8 min? Contents of moilbe phase are ACN:Water:TFA =...

08 July 2020 2,695 13 View

Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

Should we reduce the standard unit of length to 0.31951540592 meter ?

The reasoning behind this question is to align the ratios of the proton potential in energy per charge to the speed of light in distance per time. As these two dimensions appear to be related,...

27 February 2021 947 7 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

Helix antenna coupling problem?

Dealing with a helix antenna, made with flexible material and not rigid like using a PCB board or wire. At the beginning of the helix is too close to the ground plane, causing coupling. How can I...

21 February 2021 4,453 3 View

What are your alternative data collection methods during the pandemic? What are the pros and cons?

Dear colleagues We are exploring possible data collection methods for environment and behavior research in the context of architectural environments. Have you conducted any Post Occupancy...

16 February 2021 2,575 4 View

Any way to separate out fluorescent channels from a composite image?

Hi there, I've been using the EVOS Auto II microscope for some time now and usually I will save the transmitted light/bright field image and the images from fluorescent channels as separate...

15 February 2021 546 3 View

Centrality indices for weighted bipartite networks?

My colleague and I are looking to use SNA to look at the risk of contact between an intermediate and definitive host of a parasite. We have built a bipartite network where one set of nodes...

08 February 2021 6,637 3 View

Can explain this diagram to me, is this the average consumption curve for one day or the total consumption of days in a month summed up in specific?

The hourly load curves of the selected household in each season are shown in Fig. 28. Figure 28 shows the demand for electricity in four months on an hourly basis. Can you explain this diagram to...

08 February 2021 657 16 View

Is there a test network to analyze the hydrothermal dispatch of electrical energy?

Hello, I am developing my degree work on the coordination of hydraulic and thermal units in an energy network and I was wondering if there is any test network with which I can evaluate or compare...

03 February 2021 1,587 3 View