How to read a flow cytometry graph detailing cell cycle?

Hello everyone, When determining cells in different stages of the cell cycle, cells are stain for Brdu and Propidium Iodide. I understand how PI can be used to discriminate between G1 and S/G2...

18 February 2021 3,920 3 View

Despite single-cell RNA, how can I characterize a new cell subtype/phenotype?

A new cell subtype was found out only during regeneration phases after a cuprizone-induced demyelination model. How can I characterize this cell? It is important to highlight that was already...

13 February 2021 1,245 1 View

How to improve NHBE adhesion after subculture?

I'm trying to subculture NHBE cells from Lonza, however, the cells seem to not adhere to the new flasks after detachment. I've followed Lonza detachment protocol (2 mL/25 cm2 of Trypsin 0.05% and...

10 February 2021 196 1 View

How do I prepare and store insect samples for JH measurements?

I need to preserve termite samples for future quantification of juvenile hormone in their bodies. Or extract the Juvenile Hormone and keep that samples stored for future quantification. I may need...

09 February 2021 1,995 1 View

How to measure beam radius over some distance in Lumerical fdtd (Collimation evaluation)?

31 January 2021 6,354 2 View

Can someone explain why a methyl in phentolamine mesylate presents two correlations for 13C-HSQC, around the region it should appear?

Instead of appearing one single correlation of the signal of the carbon at 20.9 ppm (#11 in the attached figure), aligned to hydrogen at 2.29 ppm, it appeared two correlations (2,32 and 2,26 ppm)....

16 January 2021 4,774 2 View

How to perform Potential Surface Energy Exploration (PES) calculations?

I would like to receive help, as I am trying to make an analysis of the ethanol PES, but the calculations are always giving error. I use the conda-forge version of xtb (* xtb version 6.3.2...

04 January 2021 602 2 View

What is the best method for removing power-line interference (PLI)?

In the paper A wavelet-based method for power-line interference removal i... we propose a new method for removing PLI. This method consists in identifying the ECG and noise frequency range for...

29 December 2020 9,233 3 View

Have you done or thought about doing an article about the impact of covid 19 in your research / work area? If so, which one?

Have you done or thought about doing an article about the impact of covid 19 in your research / work area? If so, which one?

27 December 2020 3,777 12 View

How to simulate the magnetohydrodynamics (MHD) phenomena in COMSOL? What is the best way to learn how to use COMSOL?

I would like to simulate the Lorentz Force resulting from the magnetohydrodynamics (MHD) phenomenon in an ionic solution.

19 December 2020 8,278 9 View

error in running a model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

error in modelling model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

MGL tools

20 June 2021 0 0 View

How climate change will influences human and animal behavioral change?

The role of climate change influencing the human behavior as well as economics interest

01 June 2021 0 0 View

flexibility of polymers chain

effect of double bond on the flexibility of polymers

07 April 2021 0 0 View

i have some problem with chtMultiRegionSimpleFoam

--> FOAM FATAL ERROR: Maximum number of iterations exceeded From function Foam::scalar Foam::species::thermo::T(Foam::scalar, Foam::scalar, Foam::scalar, Foam::scalar (Foam::species::thermo::*)(Foam::scalar, Foam::scalar) const, Foam::scalar (Foam::species::thermo::*)(Foam::scalar, Foam::scalar) const, Foam::scalar (Foam::species::thermo::*)(Foam::scalar) const) const [with Thermo = Foam::hConstThermo >; Type = Foam::sensibleEnthalpy; Foam::scalar = double; Foam::species::thermo = Foam::species::thermo >, Foam::sensibleEnthalpy>] in file /home/ubuntu/OpenFOAM/OpenFOAM-4.1/src/thermophysicalModels/specie/lnInclude/thermoI.H at line 66. FOAM aborting #0 Foam::error::printStack(Foam::Ostream&) at ??:? #1 Foam::error::abort() at ??:? #2 Foam::heRhoThermo >, Foam::sensibleEnthalpy> > > >::calculate() at ??:? #3 Foam::heRhoThermo >, Foam::sensibleEnthalpy> > > >::correct() at ??:? #4 ? at ??:? #5 __libc_start_main in "/lib/x86_64-linux-gnu/libc.so.6" #6 ? at ??:?

24 March 2021 0 0 View

Formulation of polymer color flakes

I am writing to request some information for making polymer color flakes. I would appreciate the help.

17 March 2021 0 0 View

What kind of intervention will be relevant to increase motivation among young sport trainees?

Any suggestion on what book to read is also welcome.

03 March 2021 1,646 4 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

What is the production process of CaFe ferroalloys?

I looking for ferro calcium production process

03 March 2021 1,755 4 View