Respected sir
The different type of electrolyte used in ECM Process which electrolyte is best for ECM Process and if we are changing electrolyte the conductivity of work piece i will be change ........
it is possible or impossible ..........?
i am eagerly waiting for different answer and ideas
Greatest Regards
S.Sathishkumar
Electrolyte play an important role in machining parameters of electro chemical machining (ECM) ,usually used Nacl , NaNO3 plus H2O and each one effect to surface roughness and metal removal rate of work material but can say the NaNO3 give best result.
best regard,Dr.Saad Shather
Dear Sathishkumar,
If you investigate the literature you can see that different type of electrolytes causes different output parameters (MRR, surface roughness, oversut etc.) due to workpiece material. Three different electrolyte types can be used ECM;
1- Sludging (NaCl,NaNO3,etc.)
2-Non sludging (HCl etc.)
3-Mixed (NaNO3+HCl)
In addition i have to say that NaCl type electrolyte is the hardest one to control the machining accuracy. But most MRR can be achivied with this type of electrolyte.
Thank you so much professor ....thanks a lot .....
please its my humble request keep it tough with me because i am very small boy so lot of things learn from yours ........
Greatest Request
S.Sathishkumar
- Badges
- Science method
- Similar topics
- Chemistry
- General Biochemistry
- Biochemical Techniques
- Analytical Chemistry