In PRIMER, is it possible to downweight certain taxa in multivariate community datasets to reflect uncertainty around identification??

I have a dataset with about 80 different species. As usual, some species are very easy to identify with certainty whereas others are more difficult, which means that I am less certain of my...

03 March 2021 8,066 4 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

Gel electrophoresis result for total RNA samples, 1.5 Agarose gel was used, How to improve the integrity of RNA?

Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue

02 March 2021 5,433 5 View

How to grow E.coli on the low salt LB agar plate with 50 or 100ug/ml of Blasticidin?

Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...

01 March 2021 2,027 2 View

OpenBCI eeg--has anyone used them?

I'm looking to try out an off-the-shelf EEG set for some exploratory work. Curious if anyone has used the OpenBCI, and how much set-up work is required. I've heard they are more difficult to get...

01 March 2021 4,128 3 View

How to remove DCU and HOBT from my reaction?

I am doing a acid and a chiral amino alcohol reaction using DCC and HOBT in DCM or THF? Can anyone suggest me how to remove DCU and HOBT from a reaction mixture??

28 February 2021 2,153 1 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

B-mercaptoethanol (BME) protocol?

Hi everybody, I have been running a multiplex IHC which allow me to stain the same tissue with different markers (Primary Ab + Secondary conjugated Ab) (AF487, AF555, AF647). Since I would like to...

27 February 2021 5,028 2 View

What is the suitable range of Sulfur content and Viscosity of Heavy fluid Oil that used in Kiln?

What is the disadvantages of high sulfur content to the ceramic burning process? and what is the effect of outranged viscosity?

24 February 2021 8,219 2 View

How to use measure capacitance change in COMSOL time dependent study ?

I want to measure change of capacitance due to relative displacement between two parallel plates in COMSOL. Distance between two plates changes with time. So I'm using a time dependent study but...

26 February 2021 8,567 3 View

How to find the capacitive response frequency from the impedance plot?

I have done electrochemical impedance by using cyclic voltammetry for one organic material. from that, I plotted bode diagram. but actually, I am very confused about how to find the capacitive...

18 February 2021 3,023 3 View

How to get better phase shift in C-V curves for ferroelectric devices?

I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...

16 February 2021 8,514 2 View

How can we maintain the two different DC high voltages of same polarity between parallel electrodes inside the vacuum separated by few millimeter?

I am trying to maintain two different high DC voltages of same polarity (either positive or negative) between two parallel electrodes separated by 500 um inside the vacuum. However, what I found...

21 December 2020 1,735 3 View

How to segregate electrode-dielectric and dielctric-dielctric interface polarization after Capacitance VS Freq. measurement using impedance analyzer?

After measuring the capacitance vs frequency for my MIM capacitor consisting of alternate layers of TiO2 &Al2O3 , there is a rise in capacitance value of ~ 20-160 nF at 100 hz, starting to...

17 December 2020 7,786 3 View

How to evaluate area under the discharge curve by using Origin software?

In case of Galvanostat charge-discharge, the discharging time used to evaluate the specific capacitance using following relation: C=I*t/m*dV. But when it comes to capacity, the area under the...

25 November 2020 1,856 1 View

How to structure a Knowledge Management model, to strengthen research and improve educational quality in higher education institutions?

22 November 2020 8,558 9 View

Temporal noise analysis CMOS APS?

I was reading the paper "Analysis of Temporal Noise in CMOS Photodiode Active Pixel Sensor" but I am a bit puzzled about noise calculation during integration. In particular, can someone explain...

15 October 2020 9,597 3 View

What is relation between conductivity and capacitance ? What will be the solution of given problem ?

Consider perfect metallic conductors (red and blue) Of cross-section shown in the figure (the cross-section is centered at x = O). Let the length Of this conductor be 'L' (oriented along...

29 September 2020 2,276 4 View

How to find/make ADS or Spice model of MACOM Varactor diode MA46H071/MA46H201?

Hi, I am looking for ADS/Spice model of macom varactor diode model MA46H071/MA46H201. In the manufacturer website only the ADS model of MA46H120 is available. I do have the datasheets of all...

27 August 2020 3,534 3 View