How to find the number of packets in a queue within a device in NetSim?

In a network, I want to set the buffer size of a device and then measure the number of packets in the buffer queue. The number of packets in the queued, dequeued an dropped, I need to calculate...

12 September 2020 4,654 4 View

Is there any criteria to differentiate between crystalline and amorphous peak in XRD for polymers ?

can anyone suggest me the book to know the answer to the above question? the graph has been attached

07 September 2020 7,512 4 View

Can the optical density of the cell culture (fibroblast) be measured with a photocalorimeter? will the results vary with that of UV measurements?

I intend to use photocalorimeter to take the OD values of the cell culture tubes. I would like to know if the results would contradict that of UV readings and ultimately the concentration...

21 February 2018 4,602 3 View

Difficulty in isolating mesenchymal stem cells from mice bone marrow?

Trying to isolate MSC from mice/ rat bone marrow. Upto second passage cells are proliferating and in good morphology. When I am trying to expand the cells (second passage) cells are not attaching...

23 November 2017 9,358 6 View

How can i apply to contribute toward the vernacular architecture of karnataka in west coast India ?

i am presently writing paper on climate responsiveness of the architecture of this region. i have many case studies yet to be published on this topic. roughly 10- 15 types documented and another...

12 September 2017 9,320 3 View

How to calculate the phase concentration from XRD pattern, if a major peak is missing due to highly oriented samples?

I have taken XRD for my samples which has anatase, rutile and brookite phases. I want to calculate the phase concentration of each phase in the sample. But the problem is the major peak (high...

08 July 2016 2,228 10 View

HMSC in mice/rat xenograft models?

Can we use hMSC in mice/rat models which are not immuno compromised?

12 June 2016 5,940 6 View

Acyliminium reactivity versus enecarbamate?

Dear researchers, i kindly ask you to help me with the following aspect: in scheme 4 (of j.org. chem, vol.66,No.23, 2001) it is shown that nucleophile attacks on the acyliminium intermediate and...

08 February 2016 1,601 3 View

How to acid wash the sand? And what is the purpose of acid washing?

20 December 2015 6,849 3 View

Which is best reference gene for Real-Time PCR gene expression studies under chemical hypoxic condition?

I am trying to study the expression of my gene of interest under hypoxia (chemically induced) there were many reports that states that GAPDH and Microglobulin Beta are more stable genes that can...

03 August 2015 1,749 4 View

What are the values needed for gabor filter's parameter for cifar10 data?

Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...

03 March 2021 6,317 1 View

How to calculate Total Flavonoid?

I analyzed flavonoid total spectrophotometry, the procedure as below: 2 ml supernatan added 5 ml dd.H2O, then added 0,15 ml NaNO2 5%, 5 minutes later added 0,15 ml AlCl3 10%, After 6 minutes,...

01 March 2021 6,722 1 View

RNA-seq DEGs downstream analysis and reporting in literature?

I used EdgeR to get the list of DEGs (differentially expressed genes) from my liver RNA-seq experiment. I have done the gene overrepresentation and GSEA based pathway analysis. I am currently...

23 February 2021 8,969 1 View

What are the ranges of four diffterent poles of butterworth filter for ECG signal?

Hi, Can anyone please tell me what are the ranges of four different pole orders such as first order, second order, third order and fourth order respectively of butterworth filter for ECG...

23 February 2021 2,554 3 View

Which polarizers are usually used to measure the birefringence of zebrafish muscles?

I already found several publications on that topic, however, the specifications for the used filters are often missing. Some more specific information than "fish is placed between to polarizing...

23 February 2021 1,934 1 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Is it possible, for a limited dateset of images, to use Convolution filters + Random Forest instead of UNet?

UNet is 'relatively' recent and was invented mainly to deal with biomedical images, yet is it also possible, for a limited dateset of images, to use Convolution filters + Random Forest instead of...

21 February 2021 4,858 3 View

The type of filter paper used to filter an epoxidized oil (the mixture is an epoxidized oil with magnesium sulfate) ?

I have a mixture of epoxidized oil and magnesium sulfate wich type of filtre paper should i use

21 February 2021 3,944 3 View

Algorithms to filter corrective max and min from a set of data?

I've got this 5 year Direct Normal Irradiance data I downloaded from https://re.jrc.ec.europa.eu/. I ordered this by year and by every 24 hours because I need the DNI curve by max in summer, min...

17 February 2021 2,777 5 View

Why ICP-MS test for Teflon filters that collected PM2.5, show really high results in the millions of ug/g ?

I analyzed soil and ash samples using ICP-MS for 28 metals, then I resuspended those samples to collect PM2.5 particles in a filter using a selective inlet inlet. My only issue that Fe and Al...

13 February 2021 7,592 3 View