I am looking for references containing measured OPC/CEM I clinker (C3S, C2S, C3A, C4AF) dissolution data as hydration continues over time. This is typically done by XRD-Rietveld analysis from early (< 1 day) to over 100 days.
Many thanks.
Searching for articles or insight on determining the number of vignettes needed for a study using the Factorial Survey Method.
04 March 2024 1,680 3 View
I am hoping someone can advise on the use of the Bonferroni correction. I am struggling to understand how and when to use it. I have been part of a pilot study evaluating balance in older...
30 November 2023 7,738 5 View
HI everyone, I am looking to analyse data for my final year project and have come across some stumbling blocks. I am looking at metal concentrations at various locations and at various depths of...
12 February 2023 9,022 2 View
The image was taken using a Nikon Eclipse Ti microscope, with a LED light source. The image should be attached.
16 January 2023 4,734 1 View
I recently started a Art/Scince project but the book chapter title is incorrect. How do I edit or delete and start again?
04 March 2022 5,792 1 View
Hi all, We recently acquired a second hand Accuri C6 flow cytometer (manufactured 2012). Production and support of this model has been discontinued by BD following supersedence by the C6+. We're...
21 December 2021 7,876 2 View
I am in the middle of writing a thesis about SMs, arbuscular mycorrhizal fungi and the underground mycelium network. I am still in the research phase of my thesis but any knowledge you may have or...
10 November 2021 8,752 13 View
I know the properties of a permanent magnet change with temperature and that different magnetic materials have different temperature coefficients. If a permanent magnet has a temperature gradient...
09 November 2021 642 2 View
HI there, I am measuring total organic carbon and invert abundance along a transect that is moving away from an ancient woodland. I am unsure what statistical analysis to use. As our n=30 but we...
08 November 2021 3,762 9 View
Hi all, I'm planning an experiment about host sanctions in domesticated and wild soybean. I'm hoping to use fluorescent-labelled rhizobia in order to quantify colonisation by a competent N-fixing...
16 August 2020 5,890 2 View
I am using a windows system, what software I should use for hydration shell analysis with molecular dynamics?
02 August 2024 3,143 4 View
How to calculate percentage cumulative drug release when, Total volume of dissolution media = 250ml Added formulation was equivalent to 10mg of drug Sample withdrawn = 1ml each time Sink condition...
15 July 2024 4,192 1 View
Hello everyone, I am trying to encapsulate an essential oil in the liposomes using the heating method and encountering some issues. I am following the protocol described below, but my solution...
10 July 2024 4,083 3 View
I used forcite module of Material Studio software to simulate the dissolution of zinc production waste in deep eutectic solvent. UFF force field has been used for the optimization of molecules,...
02 July 2024 7,494 1 View
In other words, I did not use the trained XGBoost model to make predictions on the test set and then use SHAP for interpretation. The reasons are as follows: Even with the best and most...
26 June 2024 7,332 1 View
I did a frozen section of mouse brain tissue with immunofluorescence staining. My partner and I did c-fos staining together. We used different primary and secondary antibodies for different...
20 June 2024 8,989 1 View
Hello, I am making lipid nanoparticles using the thin film hydration method. Formula is DODMA:DSPC:Cholesterol:DSG-PEG2000 at 60:20:17.5:2.5 %mM in 5mM total. After hydration in sodium acetate...
16 June 2024 6,842 6 View
I have a set-up were I have a bottle with water (DI water, 0.8uS/cm). To that bottle I have added some MgO nanopowder, at a concentration of ~ 0.08mg/ml. It appears that the white powder is...
04 June 2024 9,789 4 View
The antibiotic powder is dissolved in Milli-q water and then filtered using syringe filter for the analysis.
01 June 2024 7,419 0 View
I preprared curcumin-loaded liposome by Thin Film Hydration Method using lecithin, curcumin and beta-sterol. I stained it with phosphotungstic acid and uranium acetate and took TEM images of each....
30 May 2024 6,863 2 View