27 December 2018 4 9K Report

Where can I find data about reverse osmosis desalination plants : Energy used per cubic meter, volume of water treated, modules array etc ?

More Abdeljalil Chougradi's questions See All
What is the best way to spot phosvitin stability, extracted from egg yolk, after heat treatment?

For protein extraction i found a protocol that separate phosvitin from egg yolk using ultrafiltration trough 10 MWCO then uses the filtrate. But phosvitin molecular weight is 35 KDa. So how it is...

16 April 2023 4,309 2 View

Can we consider SEM (Scaning Electron Microscope) technique as a useful one to visualise fouling layers on reverse osmosis membranes ?

I'm trying to visualise fouling layers (biofouling, organic, inorganic and colloidal) on reverse osmosis membranes. Do you think SEM technique is a practical one? are there better...

10 November 2019 6,718 4 View

What are the best practical techniques to monitor fouling in reverse osmosis desalination membranes ?

I need to monitor all kinds of fouling (colloidal, organic, scaling, biofouling) on the reverse osmosis membrane in the desalination process. what are the practical (easy and reliable) techniques...

05 November 2019 3,206 3 View

Can I patent a model used for chemical process based on previous models but with major modifications ?

Is it possible to patent a mathematical (with algorithm ) model used for variables calculation of a chemical process, knowing that there are different models patented for the same chemical process...

05 November 2019 2,871 8 View

What is the effect of cyclic feed concentration on reverse osmosis fouling ?

I'm looking for documentation and papers describing the effect of cyclic feed concentration on membrane fouling. by cyclic concentration, I mean a feed which has a non-constant concentration and...

02 November 2019 7,740 1 View

How to validate a athmatical model in reverse osmosis process ?

i worked on a model to describe a desalination reverse osmosis process. I have all the equations needed and the model is ready. the model depends on five parameters. how many experiments do I need...

27 June 2019 304 3 View

What are the typical values for Mass transfer k in concentration polarization in reverse osmosis Desalination ?

I'm looking for the typical values for Mass transfer k used in the calculation of concentration in membrane wall (cases of spiral wound and flat membranes)

28 April 2019 2,683 3 View

Where can I find the precise values of water and salt permeabilities of DOW RO membranes as a function of feed salinity ?

I need the exact value of water and salt permeabilities of DOW RO membranes for my project. Thank you.

30 March 2019 1,168 0 View

What are the values of water and salt permeabilities in common reverse osmosis membrane for desalination (filmtec membranes for instance) ?

What are the values of water and salt permeabilities in common reverse osmosis membrane for desalination ? (filmtec membranes for instance) I need precise values as much as possible. Thank you.

18 January 2019 5,690 3 View

What is the most used type of commercial membranes in reverse osmosis desalination ?

what is the most used type of commercial membranes in reverse osmosis desalination ? and where can I find data about these membranes (solvent and solute permeability, pH range, max pressure, etc...)

05 January 2019 5,209 5 View

Similar questions and discussions
Why is trifluoroacetic acid (TFA) used in c-18 column?

I would like to know the role of the TFA (trifluoroacetic acid) used on reverse phase chromatography c-18 column. It's is often used with a concentration of 0.1% on the mobile phase.

23 July 2024 8,075 3 View

What happens in snapTotal- seq?

What happens in snapTotal- seq? (Single-cell Total-RNA Profiling Unveils Regulatory Hubs of Transcription Factors https://www.nature.com/articles/s41467-024-50291-3) In this protocol, several RT...

18 July 2024 10,010 0 View

Is DNase I (RNase-Free) necessary to be used before cDNA synthesis?

I want to isolate RNA from bacillus subtilis using the QuickRNA Fungal Bacterial Miniprep Kit from Zymo Research and further reverse transcriptase to cDNA using the ReverTra Ace qPCR RT Master Mix...

27 June 2024 2,951 5 View

Is Polyethylene terephtahalate (PET) back support is suitable for electrospun nanofibers for forward osmosis membrane preparetion?

Recently, I am preparing novel electrospun nanofibers for forward osmosis membrane preparation, I am facing following problems: 1. While testing water flux, there is little leakage, although the...

28 May 2024 8,510 2 View

How to increase molecular weight or further polymerize cellulose triacetate?

Hi all! I would like to know if there is a method to polymerize low MW cellulose triacetate (e.g. re-engaging in acetylation). Or this is not possible and the MW of my cellulose source should be...

08 May 2024 5,260 1 View

How could I remove and delete my below publication from ResearchGate?

National Water Security: Sustainable Desalination Integrated Waste Management in Abu Dhabi, UAE

06 May 2024 3,577 1 View

Is it okay to start with different amounts of RNA in reverse transcription?

The amount of total RNA used by each group was different during reverse transcription. Can it be compensated by adjusting the same CT value during PCR?

29 April 2024 8,725 8 View

16S rDNA and RNA extraction, reverse transcription RT-PCR and real-time RT-PCR ?

Hi all earlier I have seen in some papers people go for DNA extraction and normal PCR using 16S rRNA primers for the identification of bacteria. However recently I have seen few papers...

22 April 2024 5,332 2 View

How to synthesis the uniform polyamide active layer on the aminated PVC support layer?

we work on forward osmosis membrane. the support layer is aminated PVC and the active layer is polyamide. for synthesis of polyamide , I follow the routine methods of interfacial polymerization...

19 April 2024 3,574 1 View

Which buffer is suitable for the Separation of Compound containing sulphonic acid group (-SO3H) and also has Boronic acid in it in Reverse phase HPLC?

I have synthesized a sensor, which has sulphonic acid grp (-SO3H) and Boronic acid as well in it. And has a Molar mass of around 899 and also has an amide bond in it.. I am using Reverse phase...

13 April 2024 7,502 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close