I will be using ethanol, proplyne glycol and water as solvents for the drug bimatoprost. Should I use denatured or undenatured? Thank you very much!
Will using denatured harm the drug or skin permeability properties? Everywhere I look, it says bimatoprost is used with ethanol, but it doesn't say which kind. Does it matter?
Hi, I think denatured ethanol because of the cyt induction. We must reduce this induction to min value.
Out of all that is approved and unapproved and also out of all that is proven and simply rumored to or that may work, what is a list of effective hair loss prevention agents? Preferably for male...
04 May 2016 823 2 View
How would you make a solution or ointment (or otherwise) containing sucralfate where the sucralfate molecules are able to penetrate the skin?
02 March 2016 9,614 2 View
I asked if isopropyl alchohol could be used in place of ethanol in an earlier posted question and it seems that neither is suitable to dissolve sucralfate. I will be making a solution that is to...
02 March 2016 4,514 5 View
I have two problems given in my textbook that the book unfortunately does not give a good amount of information on. I have the answers in the back of the book, but I need to know how to do this....
08 September 2015 7,773 1 View
07 August 2015 8,778 0 View
I would like to know how a childs father can be determined through a paternity tests. What is the full process? What are the names of the tests involved? What is needed? Is it always accurate? Is...
06 July 2015 1,150 0 View
Want people who have been through med school to list all the books they read while attending and the books that helped the most. Thanks!
06 July 2015 5,468 0 View
04 May 2015 8,562 0 View
If I have a powdered or ground plant, how can I make a petroleum ether extract of it?
03 April 2015 6,711 15 View
01 February 2015 942 10 View
Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1
17 August 2021 0 0 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
20 June 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
effect of double bond on the flexibility of polymers
07 April 2021 0 0 View