I will be using ethanol, proplyne glycol and water as solvents for the drug bimatoprost. Should I use denatured or undenatured? Thank you very much!
Will using denatured harm the drug or skin permeability properties? Everywhere I look, it says bimatoprost is used with ethanol, but it doesn't say which kind. Does it matter?
Hi, I think denatured ethanol because of the cyt induction. We must reduce this induction to min value.
I am in search of those who are familiar with the French & European societies at the end of 1700s to join me in writing a book as my co-authors. The book is on Marie Antoinette. Looking at...
01 October 2020 9,095 5 View
I am trying to detect any differences in DNA damage/apoptosis related proteins by western blot between wild type and disease cells. I ran an initial WB and saw no bands for either protein and am...
18 November 2019 7,204 4 View
We have two Binder incubators which we'd like to check the CO2 concentration in. On our Thermo incubators we used a Fyrite Gas Analyzer but these incubators don't seem to have a port to measure...
14 November 2019 7,586 1 View
Hello, I am doing some research for my dissertation and require meterological (ppt and temp) data for Spiti Valley, Himachal Pradesh. Although I have found some data for the Lahul and Spiti...
15 October 2018 7,769 4 View
I'm trying to interpret the results of Co-correspondence analysis (CoCA) with the R package cocorresp. The descriptive paper is rather unclear about how to interpret the results. I've performed...
25 February 2018 2,999 2 View
How would you make a solution or ointment (or otherwise) containing sucralfate where the sucralfate molecules are able to penetrate the skin?
20 March 2016 3,437 2 View
13 March 2016 4,920 2 View
14 December 2015 5,519 7 View
I have been treating cardiomyocytes with various amounts of doxorubicin (between 250nM-2uM) and running my cell lysates (20ug protein in RIPA with protease /phosphatase/deacetylase inhibitors) on...
24 June 2015 8,712 3 View
If I have a powdered or ground plant, how can I make a petroleum ether extract of it?
13 April 2015 2,009 15 View
Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1
17 August 2021 0 0 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
20 June 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
effect of double bond on the flexibility of polymers
07 April 2021 0 0 View