What is the maximum additional serial deadspace for mainstream capnography in mice?

06 June 2013 0 5K Report

While 0.1 mL in our developed sensor was low enough for rats, it might be a too high fraction in mechanically ventilated mice. What is the maximum in mechanically ventilated mice lung injury model? Is there a publication that supports this particular opinion?

Article Capnography-based analysis of dead space in rats during spon...

Badges
Science topic

More David Schwenninger's questions See All

How to dimension a motor for a turbine?

How can I or where can I find information about how to determine torque and rpm of a motor to produce a given maximal flow and maximal pressure with a centrifugal turbine? For e.g. this one:...

08 September 2013 9,645 1 View

How the parameters (such as Mw, Chemical bonds, polymer bland and so on) affect the mechanic property of polymer (such as storage, loss modulus) ?

Anyone can recommend any books on such topics? Thanks in advance.

02 March 2021 8,457 2 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

What analysis to choose with a large neste dataset and clearly skewed or kurtotic distributions?

Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...

02 March 2021 6,865 1 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

How to make a time series imputation benchmark ?

Hello ! In a work, I have to benchmark different algorithms to fill in missing values in time series. I insist on the fact that this is imputation and not forecasting. In my case, I have access...

24 February 2021 7,470 7 View

What are the pros and cons for mice versus rats?

Hi Everyone, I am designing a pilot study using rodents to assess the effects of simulated space environments (radiation + altered gravity) on microbiome and immune system. I have limited...

24 February 2021 1,825 3 View

How can I verify my centrifugal fan design for electric motor cooling?

I have radial blade centrifugal fan design which will be mounted on exhaust side of electric traction motor. The fan will be mounted on same motor shaft inside the housing. How can I verify that...

23 February 2021 2,390 3 View

Have you ever experiencing air vent trouble in fermentation process?

Dear all, My research group is currently working with a 12-litre fermenter. Somehow, if we do the fermentation for more than 20 hours, the process will be more prone to contamination. Our current...

23 February 2021 1,908 2 View