I have installed pilot scale membrane bioreactor and pressure sensor psa-C01is also installed for TMP so pressure is shown in negative value.. What is their effect on fouling for tmp if their negative value is increased.
Please go through
www.researchgate.net › publication
(PDF) Effect of a suspended carrier on membrane fouling in a ...
https://www.google.com/url?sa=t&source=web&rct=j&url=https://www.mdpi.com/2077-0375/10/2/24/pdf&ved=2ahUKEwiVo9Td78fvAhVOY8AKHQ7XBdQQFjAAegQIBRAC&usg=AOvVaw2F7CZUGFVusCiOlBrQUDR5&cshid=1616552619282
Dear Ihsan Wassan you can try links below:
Article Effect of pressure on fouling of microfiltration membranes b...
Article Effect of pressure relaxation and membrane backwash on adeno...
https://www.mdpi.com/2227-9717/2/4/795/pdf
Regards
How we can dissolve Fe doped titanium dioxide nanopartcles prepared by sol gel method and which solvent gives good results. Your suggestions are really appreciated.
10 January 2021 6,838 2 View
My name is Apurva Saoji. I am a Ph.D scholar in Computer engineering in India. I am looking for international expert in reviewing my PhD thesis, "Competitive Optimization Techniques to Minimize...
07 August 2024 4,600 2 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...
30 July 2024 3,294 3 View
need of sensor details or sensor development for this question.
28 July 2024 4,539 3 View
Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?
25 July 2024 5,482 2 View
Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...
21 July 2024 1,680 2 View
Hello, I am currently working with Malaria Pf/Pan nitrocellulose membranes coated for malaria detection. After drying the coated membranes in an Incubator (overnight at 37°C), I've noticed that...
16 July 2024 7,937 1 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I try to understand the ESP mechanism working. What kind of sensors it has, Is it necessary to modify or boost its mechanical ?
15 July 2024 4,772 1 View