Hello,

The boundary conditions will depend on how they are attached. As far as I develop it is fixed immovably in the four and the end. Located horizontally with the larger side. The earth weighing works on it. Then the odd parameter is also the type of material and the total mass of the plate. It is necessary to specify the method of attachment (a pre-assembled or non-dismountable joint) of a welded or bolted joint. Wind loads caused by wind, etc., can also be applied.

Wishing for success in scientific research.

Emil Yankov

Hello Claudio,

Thanks for your answer. I understood that load acting doesn't have a role in constraining of boundary conditions. I will try with the appropriate boundary conditions and then check with analytical solutions.

- Meikanth

Hi Emil Yankov ,

Thanks for the answer and wish.

-Meikanth

İ think this article could help:

https://www.researchgate.net/publication/332990860_Modeling_and_Buckling_Analysis_of_Rectangular_Plates_in_ANSYS