I want new articles about 1,2,3-triazole derivatives as corrosion inhibitors for steel
Article 1,2,3-Triazole derivatives as corrosion inhibitors for mild ...
http://corrosionjournal.org/doi/10.5006/1.3277657
Article Study of a Triazole Derivative as Corrosion Inhibitor for Mi...
https://www.hindawi.com/journals/ijelc/2019/6759478/
Hi Faeza
Take a look at the link below:
Article Occurrence, toxicity and transformation of six typical benzo...
There are different types of articles about using Triazole derivatives as a typical corrosion inhibitor.
Regards
1- https://www.jmaterenvironsci.com/Document/vol9/vol9_N2/49-JMES-3469-Rouifi.pdf
2- https://www.sciencedirect.com/science/article/abs/pii/S0022286018310998
3- https://www.mdpi.com/1420-3049/18/12/15064/htm
Thanks for all
Article Synthesis of 1,2,3-Triazole Derivatives and Its Evaluation a...
Article A Review on 1,2,4-Triazole Derivatives as Corrosion Inhibitors
Hello researchers. I am looking for better ways to explain the results in a quantitative and qualitative studies but I don't know how. Do you have any recommendations for that issue? Thank you in...
12 January 2019 5,754 2 View
What are the best ways to measure student's achievement?
01 January 1970 1,183 8 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 717 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,027 0 View
Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container
30 July 2024 7,326 1 View
I am currently working on a project that involves extracting cell membranes, for which we disrupt the cells using sonication. During the initial extraction process, we add protease inhibitors to...
30 July 2024 7,077 1 View
The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...
27 July 2024 8,507 0 View
Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?
25 July 2024 9,408 0 View
In general, when performing a Tafel analysis for corrosion resistance measurements, a line voltage scan is performed from say -250 to +250 mV vs. OCV at low scan speed around 0.125 mV/s. However,...
25 July 2024 7,982 3 View
I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...
24 July 2024 4,393 2 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,488 2 View
I am simulating interlocking / dry stacked masonry in Abaqus. I am using a friction coefficient of 0.6 for my model as it is stated in the previous research as well as in the base paper. The...
16 July 2024 5,047 0 View