Fluorescent tyramide protocol ?

Hello, Im asking to check if anyone has a protocol for preparing fluorescent tyramide for fluorescent in situ hybridization. The one Im using isnt working, so if anyone has one that works, can you...

05 November 2020 9,566 3 View

How can I fix our rodent's treadmill?

Our rodent'treadmill's bars show voltage but not affected animals. I cleaned all those bars as rat's urine is dielectric. Do you have any idea that helps me? Thanks

20 September 2020 5,971 2 View

Assessment of the exercise intensity?

Hi, How can I assess the intensity of a treadmill exercise in rats without measuring Vo2max? I mean how can I know a specific protocol has a low or high intensity without measuring any factors...

01 September 2020 3,788 5 View

Hi all, I would like to know the intensity of these two treadmill protocol are the same in Rats?

I would like to know in two different treadmill protocols, if we are going to reduce the treadmill velocity for rodents (14 m/min instead of 20 m/min) but increase the time of exercise (60 min...

23 August 2020 350 2 View

What is the talents' best identification tool?

There are different identification tools to identify talented individuals, which tool you think is the most successful one to properly identify them?

04 October 2019 5,734 3 View

Problem in Wi Fi connection ?

I have a problem with the modem (D-link). When you set up the modem, I connect normally, but after a few time, the Wi-Fi network is disconnected and when I try to re-enter in the network, it does...

03 September 2019 8,187 4 View

What's the simplest method to determine the HOMO and LUMO energy levels of insoluble organic semiconductors?

HOMO and LUMO energy levels determination is un important step to confirme organic materials application in OSCs

19 February 2019 1,327 5 View

According to SJR, there are a Cataloging and Classification Quarterly (Q1, Q2, Q3 and Q4). I would like to know the Q1 and Q2 of psychology journals?

Dear Colleagues, According to SJR, there are a Cataloging and Classification Quarterly (Q1, Q2, Q3 and Q4). I would like to know the Q1 and Q2 of psychology journals? Thanks a lot

08 September 2018 8,737 1 View

No title

24 May 2017 3,415 18 View

Colony PCR, Product, recombinant Colony?

02 January 2017 6,959 8 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to prepare a thin polymer film by post-polymerization/crosslinking?

24 February 2021 2,362 5 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

How to improve the adhesion between germanium and silicon monoxide thin film layers using EBEAM evaporation?

I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?

21 February 2021 2,141 3 View

How can I measure the thickness of thin layers deposited on textured glass susbtrates?

I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.

21 February 2021 5,465 4 View

How do I calculate absorption coefficient of my thin film if I dont know the thickness? Or how can I calculate the thickness of my sample?

I have done Uv-vis characterisation of my thin film and have received absorbance and transmittance data. Now I want to calculate the absorption coefficient but I dont know the thickness of my...

21 February 2021 7,148 8 View

How to construct different filler shape in MD simulations?

Is there any way to construct different initial filler shapes like triangle, square, rectangle, pillar, and tube in any simulation software.

20 February 2021 1,750 1 View

Can fractal dimension of thin film surfaces affects the electrons energy states?

As fractal dimension of a thin film surface implies the irregularity in the surface. Is it possible that the energy states of the electrons are also affected by the fractal dimension?

19 February 2021 5,509 3 View

What is the reason film thickness increased?

what is the reason film thickness increased when increased doping concentrations give some reasons The measured film thickness is 156, 282, 394, 548 and 681 nm for 0, 1.5, 2.5, 3.5, and 4.5 wt....

17 February 2021 8,987 5 View

How to visualize stress in a coating defined by "Skin" in Abaqus?

Hello All! I'm trying to model a contact between a coated substrate and a tip in Abaqus. The coating is ultra-thin compared to the geometry of the substrate. So I defined the coating using the...

16 February 2021 1,594 3 View