Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Satellite orbit estimation using Recurrent Neural Network - what should I use?

Hello, I am a master's student studying in Yonsei Univeristy, Korea. I am trying to estimate the state of satellite, using Neural Network. Below is a simple flow of my study. 1. Train (t0 ~ t1)...

23 February 2021 6,383 3 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View

How many days do we need to detect adoptively transferred Treg in the tumor site in tumor-bearing recipient mice?

Hello, I've got a plan to isolate mouse splenic Treg (WT and KO of target gene) and inject these CD45.2 Treg into tumor-bearing CD45.1 mice. My question is how many days do I need to wait to see...

11 February 2021 8,238 1 View

Is it possible to antibody labeling with FITC cause antibody disfuction?

Hello, I studied how much bound my test antibodies to the target antigen using FITC labeling to test antibodies. I tested 3 types of antibodies, the elisa binding affinity and cytotoxicity...

07 February 2021 8,335 2 View

Can you use MTS assay with cells cultured in media containing phenol red?

I am trying to run a cell viability assay with LN229, but these cells are cultured in DMEM which contain phenol red. Is the MTS assay sensitive to the additional of phenol red in the media? If so,...

03 February 2021 9,478 2 View

Lighting for open field test behavior assay?

I am currently setting up our lab's behavioral space to run the open field test in rats, and I am trying to figure out how to set up lighting to evenly illuminate the open field chamber (a 90 cm x...

26 January 2021 1,399 3 View

Is there a surface inactive water-soluble dye?

Hi guys, I'm looking for a water-soluble dye which is not surface inactive in order to observe (water in oil) emulsions; I don't prefer to use oil-soluble dyes. I've used rhodamin123,...

21 January 2021 8,496 2 View

Can I calculate the average from the data which are collected every 30 minutes for ANOVA?

I artifically elevated the air temperature in the heated plot by 3-celsius degree compared to that in the control for 7 days. I want to figure out the effect of the temperature manipulation on...

21 January 2021 1,185 8 View

Should we change media after1st 6hrs after plating HUVEC bought from INVITROGEN?it's not recomended by invitrogen.Will DMSO present in stock matter?

We have HUVEC bought from Invitrogen. Cat no -C-003-5c. while first plating the cells we have bought the protocol suggests not to centrifuge the cell with media to remove the DMSO. Should we...

02 March 2021 3,713 2 View

Bought HUVEC from Invitrgen.need to revive it.expected it is cryofreezed in DMSO.Do I need to remove the DMSO for plating the cell for the 1st time?

After I cryofreeze the cell do I need to remove the DMSO for culturing the cell for next passages .

28 February 2021 7,738 3 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

How to dilute Toxin-DMSO solution?

I have a concentrated solution of a toxin(50 micromolar) in DMSO 100%. I need to dilute it inorder to dilute both the toxin and DMSO wich can be toxic to cells. Which would you guys recommend to...

19 February 2021 7,447 2 View

How to successfully revive cells stored at -80 degree C for a year?

I am working on C6 cells along with other neuronal cell lines. We have preserved the cells in 90%FBS and 10% DMSO solution. We are reviving the cells after a year and cells are either not binding...

18 February 2021 4,499 1 View

How can I make sure that BCTC doesn't fall out of solution/form DMSO crystals when treating cells?

I resuspended my BCTC as described on the bottle at 10mg/mL in DMSO. However, I can see the formation of crystals which I can only assume are DMSO and that the drug is precipitating out of...

14 February 2021 5,633 1 View

Can anyone suggest a way to dissolve insulin which is for rat/mouse injection?

We are trying to inject insulin to rat or mouse, but the insulin we've got is powder, and there are many ways for dissolve, like in saline, PBS, DMSO, or in Tris-HCl, can anyone give us a...

13 February 2021 8,426 10 View

DMSO concentration in cell culture? Precipitating while PBS is added?

I am testing a compound on RAW 264.7. the compound is soluble in DMSO. but to ensure that final concentration of dmso is not more than 0.1%, we are first dissolving it in dmso and then diluting it...

11 February 2021 1,136 3 View

What are the main conditions suited for synthesizing a PVDF thin film by solvent casting method?

I have been trying to synthesize PVDF thin film by solvent casting method. I started by using 2:3 DMSO: acetone as solvents. The solution was stirred for 3hrs at 60 deg and was dried at 90 degrees...

09 February 2021 8,850 3 View

H2O2 scavenging activity problem??

When I do the test of plant against the free radicals of H2O2 the control had a value about 0.9126 The critical point is when I prepared the extract with DMSO the absorbance appear more than 2...

09 February 2021 6,430 2 View