Silicon or any other material a electron of an atom spin can be controlled?

04 April 2013 1 7K Report

Is this possible ?

If possible how?

What is the advantage if we use this technique?

Controlling of electron spining can done , this techniques used mainly in MRI (Magnetic Resonanse Imaging) if you back to MRI princible you can find out how to control the spining by using magnetic waves .

Badges
Science topic

More Shanthi Swaroop S.'s questions See All

The structural health monitoring system are using PZT sensor, why they are preferred?

Structural health monitoring system are used to monitor the health of the architecture of the plane and constructions when they are monitoring , they used piezoelectric sensor to log the data. Why...

01 February 2018 4,905 5 View

How to find relative permittivity and permeability of a material?

I have to find a dielectric constant of a particular material. for ex. I need a titanium or combination of carbides.

03 April 2014 2,408 3 View

Why is semiconductor material segregated into p- type and n-type?

If silicon or germanium or any of the semiconducting material for function using the same material, what will happen when P-type is silicon and N-type is germanium combine together? Due to the cut...

09 October 2013 9,437 4 View

I need a 0-20mA isolating amplifier current circuit. Can someone help me please?

These is for making a input to the control board to set up the current value according to that it will the maximum current .

07 August 2013 3,429 3 View

What is energy gap?

Regarding a semiconductor where there is a conduction band & valance band.

04 May 2013 8,427 3 View

What is the correlation between electromagnetic waves and material ?

Due to the material characteristic the producing of EM waves will have any variation, if it is there in which material will EM be effective?

04 May 2013 5,087 4 View

What is the concept of plasma immersion ion implantation?

It is related to high voltage sputtering. What is the purpose of using this technique, on which law it is working?

03 April 2013 9,551 5 View

What softwares are used for simulating and modelling pvd?

What software is used for physical vapor deposition and x-ray photo electron spectroscopy and plasma immersion ion implentation?

03 April 2013 3,137 2 View

What is the concept behind physical vapor deposition?

Using high voltage sputtering.

03 April 2013 6,360 1 View

Does the battery utility have any difference from a fixed point communication to hand off communication?

Assume that while travelling in bus or train we are standing at point having a communication and having a conversation on our mobiles. Is there any difference in battery usage from these two modes?

02 March 2013 1,589 9 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Handling Missing Data and Building a Predictive Model with Incomplete Information ?

I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...

10 August 2024 4,005 2 View

Which Scopus Journal provides the most affordable fees?

"PUBLISHING IN A SCOPUS JOURNAL" Researchers are now at a cross road. The critical need to publish in a Scopus or ISI, etc journal is ever vital. Journal Publication fees must be submitted....

10 August 2024 8,621 1 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Seeking Advice on Viability and Execution of Undergraduate Thesis Topic?

Hello everyone, I am currently developing a thesis proposal and would appreciate your input on its viability and how to effectively carry it out. My proposed topic is: "Does the perceived threat...

10 August 2024 8,992 0 View

Is it possible to use the Fused Deposition Modeling (FDM) to additively manufacture interconnected porous structure generation of >100-200 micrometer?

Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...

09 August 2024 7,892 0 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

Who will be moral responsible for the death of thousands of people in the event of an earthquake?

Who will bear moral responsibility for the deaths of thousands of people in the event of an earthquake? Weeks and months remain before the onset of strong earthquakes that bring death to...

08 August 2024 6,134 12 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View