Shot Peened Surface Characterization Using 3D Metrology
http://www.nanovea.com/Application%20Notes/shotpeenedsurface.pdf
Shot Peen Hardness With Nanoindentation
10 November 2011 6,390 0 View
Viscoelastic Analysis With Nanoindentation DMA
09 October 2011 10,034 0 View
09 October 2011 3,444 0 View
09 October 2011 2,218 0 View
Hardness mapping has been widely used to assess the variation of Mechanical properties across a large surface area. However, with the study of applications such as glass it is the crack initiation...
08 September 2011 6,927 0 View
When lubrication is applied to reduce the wear/friction of moving surfaces an increasing load can shift the lubrication from several regimes such as Boundary, Mixed and Hydrodynamic Lubrication....
07 August 2011 9,022 0 View
07 August 2011 9,322 0 View
Irvine, CA – Nanovea introduced its patent pending breakthrough method of reliably acquiring yield strength through indentation; ultimately replacing the traditional tensile testing machine for...
06 July 2011 2,491 0 View
July 14, 2011 – Irvine, CA – Nanovea today introduced its patent pending breakthrough method of reliably acquiring yield strength through indentation; ultimately replacing the traditional tensile...
06 July 2011 3,399 1 View
06 July 2011 9,970 4 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Generally, the target material is Mo, Co, Cu, Fe, Cr, etc, so on what basis should we choose this material?
31 July 2024 5,824 0 View
Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container
30 July 2024 7,326 1 View
Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco
29 July 2024 2,163 1 View
The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...
27 July 2024 8,508 0 View
Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?
25 July 2024 9,408 0 View
I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...
24 July 2024 4,393 2 View
We assume that there is a physico-statistical meaning to the constant π other than circular geometry, but the iron guardians of the Schrödinger equation deny this. The iron guardians of the...
22 July 2024 4,285 9 View
I am simulating interlocking / dry stacked masonry in Abaqus. I am using a friction coefficient of 0.6 for my model as it is stated in the previous research as well as in the base paper. The...
16 July 2024 5,047 0 View