Is IMPACT FACTOR justified in case of Taxonomy?

There is huge pressure of getting good impact factor on scholars now a days. On the other hand Taxonomy is a very dry subject and the concerned papers can only get citation in same group of organism.

26 February 2021 5,851 1 View

Why tick's salivary gland extract didn't run in the gel (SDS PAGE )??

Greetings, I want to make SDS PAGE for my sample (Tick salivery gland extract), I tried concentrations 10%, 12%. I also tried high molecular weight ladder. But the protein stopped at the top and...

25 February 2021 7,698 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

How to measure the pH of Peat Soil?

Peat possess organic content above 75% and is highly acidic in nature (i.e. pH < 4). Before commencing stabilization, it is mandatory to know about the pH level of peat. Therefore, your...

18 February 2021 9,424 7 View

How to Measure Consumer Willingness To Change from petroleum-fueled vehicle to electric vehicle?

I wanted to calculate the probability of one consumer shifting from using a petroleum-fueled vehicle to an electric vehicle. Since my background is in engineering I do not know much about how to...

15 February 2021 9,190 5 View

Having trouble mounting the sections on the slides for IHC staining, what solution should I use?

Hello everyone, I just started learning IHC staining and I have some frozen sections to practice with in a 96-well plate. I'm having trouble mounting the sections on the slide, a colleague told me...

08 February 2021 6,880 3 View

How to use Image Lab to take an image for the bands and the ladder in the same image merged together in Western Blot?

Hello everyone. I was trying to use Image Lab software to take an image of both the ladder and the samples merged together in one image to see the position of the bands according to the ladder MW,...

04 February 2021 9,996 2 View

Need a research paper for multi speaker and single microphone acoustic echo cancellation?

Hi, I am working on a problem that involves multiple smartphones/tablets. All devices are playing the same sound with synchronization difference up to +- 5ms. Now, there is an echo issue and I...

02 February 2021 5,929 3 View

Can I use the result from a pilot study to decide the minimum sample size ?

Can I use the result from a pilot study to decide the minimum sample size required to compare the means using independent sample t-test ? Or any other way that can help me to determine the...

29 January 2021 7,677 6 View

How to prepare secondary antibody from lyophilized antibody?

So I'm new to lab research and learning Western Blots these days. I ordered my secondary antibody and it arrived in a powdered form. Here is the...

27 January 2021 5,402 3 View

Wave velocity and rock density paradox?

Practically it is known that seismic velocity increases as rock density increases, why then does the wave velocity equation involving elastic moduli and density indicate that velocity is inversely...

09 February 2021 1,843 3 View

Can this beam be behave like a ductile beam?

These beams have the same deep as the waffle has, and they have been detailed just like a beam for seismic requirements. Can these beams and columns act as a ductile frame?

20 January 2021 9,430 2 View

How can the moment tensor inversion results can present good waveform fit (synthetic and observed waveform) from generalized Cut and Paste scheme?

Depending upon the distance of the seismic station from the epicentre, the quality of waveform data and the improvisation of the synthetic waveform on it is often a question. If the Pnl waveform...

31 December 2020 6,602 2 View

Is surface embrittlement unavoidable after spray coating with brittle powder ?

I am not an expert at materials science. However, when I look at the literature, I read a process called cold spraying. This process is basically spraying a ductile powder (e.g. copper) onto a...

07 December 2020 5,378 2 View

Cane we produce any brittle (CdTe, InSb) or ductile (Ni) electrodeposited thin films superplastic just by making ultrafine grained microstructure ?

I have seen in literature and myself experienced high ductility in some pulse electrodeposited Ni and Ni alloys such as Ni-Co and Ni-W thin films. This high ductility is due to the superplastic...

04 November 2020 4,112 2 View

Petrel- well coordinates issue?

Hi, After loading 2D seismic lines in Petrel, I added three exploratory wells ( which supposed to be within the same 2D area) but these wells appears off the interesting area when I visualized...

25 October 2020 8,272 4 View

I have a list of properties of tool steels here. Please let me know which of the below mentioned properties will change after heat treatment?

16 August 2020 730 8 View

Is the heat treatment in open atmosphere an effective method for decrease carbon on surface graphitic cast iron?

The target is removing or decreasing free carbon on the external surface of gray and ductile iron.

09 August 2020 612 2 View

How to identify the appropriate sites and design a passive seismic survey in order to support the site characterisation?

In the case of overpopulated cities, how I can select the appropriate sites to do some field measurements "Passive Seismic Surveys"? How about the design of the survey in order to study the soil...

04 August 2020 5,253 4 View

Could someone suggest good journal/article realted to energy dissipation through hysteretic behaviour?

Currently I am working on " Quantitative Assessment of dissipated energy from structural components correlation with deformation under seismic loads in low rise building using Perform 3D".

13 July 2020 3,330 2 View