is there any one who can help me to model a reinforced concrete beam with Abaqus?give me the steps from the scratch?
This would be helpful to you.
You can find some tutorial in Youtube as well.
Following link will help you to understand the Reinforced conceret beam modeling with Abaqus.
https://www.youtube.com/watch?v=pGfbQxHVtzA
hi,i want to specify a distributed line load in abaqus by pressure load,but in pressure load we must select a surface. is there any one who can give me a tip? thanks.
08 September 2015 2,931 1 View
hi there, is there any one who can tell me is initial stress in predefined load exist by own in abaqus 6.10 or we shoud define it in subroutine?
04 May 2015 1,481 0 View
how can we define material property in abaqus? especially elastic and plastic coefficient of reinforced concrete?
04 May 2015 3,980 3 View
how can i install abaqus 6.1.10 on windows 8
01 February 2015 2,484 0 View
is there any one who can put me on the way escaping windows checking system during the installation of abaqus 6.1.10 on windows 8?best regards.
31 December 2014 6,911 6 View
how can we model a wire rope?
06 July 2014 8,016 2 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
I have input a moment load in module load Abaqus, i put my moment load on the node surface (using reference point). I have define moment in history output and make a set for moment too. But the...
08 August 2024 4,831 4 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
A Markov-like Model for Patient Progression" Markov Chain Monte Carlo (MCMC) Markov Chain Monte Carlo (MCMC) is a powerful computational technique used to draw samples from a probability...
05 August 2024 10,079 0 View