how can i install abaqus 6.1.10 on windows 8
hi,i want to specify a distributed line load in abaqus by pressure load,but in pressure load we must select a surface. is there any one who can give me a tip? thanks.
08 September 2015 2,931 1 View
hi there, is there any one who can tell me is initial stress in predefined load exist by own in abaqus 6.10 or we shoud define it in subroutine?
04 May 2015 1,481 0 View
how can we define material property in abaqus? especially elastic and plastic coefficient of reinforced concrete?
04 May 2015 3,980 3 View
is there any one who can help me to model a reinforced concrete beam with Abaqus?give me the steps from the scratch?
03 April 2015 8,507 3 View
is there any one who can put me on the way escaping windows checking system during the installation of abaqus 6.1.10 on windows 8?best regards.
31 December 2014 6,911 6 View
how can we model a wire rope?
06 July 2014 8,016 2 View
I have input a moment load in module load Abaqus, i put my moment load on the node surface (using reference point). I have define moment in history output and make a set for moment too. But the...
08 August 2024 4,831 4 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I attempted to make a privately uploaded text public but a window appeared that said an error occurred. There was no explanation provided as to why there was an error or what might be done to...
05 August 2024 8,025 7 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
Hello, colleagues. Recently, I have been working on a metal processing simulation with my UMAT in Abaqus. I have outlined the corresponding simulation, but I keep encountering issues that cause...
30 July 2024 7,062 1 View
DOS version.
29 July 2024 6,064 1 View
I am trying to run a restart analysis, which imports deformed configurations of parts from a generated ODB file. It runs fine in Windows OS but when I try to run it in Linux OS, it is giving some...
29 July 2024 9,572 3 View
Sure, here is the translation: I have a 3D orthogonal woven composite structure where warp, weft, and binder yarns are oriented in three directions. After modeling these yarns and the matrix in...
28 July 2024 8,169 0 View
hi, I am doing a risk analysis of a cylindrical fuselage with windows. I have applied contact interactions between the different parts, and I have applied a unit value load to a reference point,...
20 July 2024 647 2 View
Hi all, I am using the element deletion process based on a Tsai-Wu criterion through a UMAT with a specific State Value controlling the process (DepVar -> Variable number controlling element...
17 July 2024 1,501 1 View
