Can any body Guide me for Solar Load Model Example
As i want to calculate pressure drop or increase due to heat addition due to Solar load.
Dear Nikhil
It's quite easy to active solar load in ANSYS and study about it's effect on increasing / dropping pressure in a pipe. first you should make a 3D model from your pipe and read the mesh file in ANSYS Fluent then you should use DO radiation model or DTRM. in DO radiation model you have a solar calculator and you could simulate your model with that. If I find an example I would send it to you.
Good Luck
I have found a website that has an example about Using the Solar Load Model in Fluent. I hope it would help you a lot.
http://www.padtinc.com/blog/the-focus/using-the-solar-load-model-in-fluent
Good Luck
Sir As i gone through it and Prepare case file and .dat file and getting Error As Below
Dot product of flow direction and area normal is zero. Check the specified flow direction on Mass Flow Inlet boundary conditions for thread 13.
Sir I attached .dat file and case file also
- Badges
- Science topic