As i have prepared second generation model of engine in SIMULINK and i want to apply force (if Possible Pneumatic force -compressed air flow) on piston and want to observe dynamics of crank
Thank you sir for your fast reply As i am Little bit aware of Sim scape
sir in Pneumatic Piston Chamber - inbuilt piston chamber is there. In my case i want output of crank shaft torque by supplying compressed air to piston head over there expansion of air occurs and develop forces and push the piston and through connecting rod crank rotates.
& I have crated piston cylinder connecting rod crank assembly in CAD software mechanism and imported in MATLAB simulink. As here with i attached file .mdl file also.
You can find good example and explanation at
http://www.mathworks.com/help/physmod/sm/mech/ug/applying-motions-and-forces.html
regards
m.dal
You can used "Matlab Function" block, that you can write C code or Matlab code.
You can use Actuator blocks to perform the task, Visit http://www.mathworks.com/help/physmod/sm/mech/ug/applying-motions-and-forces.html for better Understanding
Thank you sir for your fast reply As i am Little bit aware of Sim scape
sir in Pneumatic Piston Chamber - inbuilt piston chamber is there. In my case i want output of crank shaft torque by supplying compressed air to piston head over there expansion of air occurs and develop forces and push the piston and through connecting rod crank rotates.
& I have crated piston cylinder connecting rod crank assembly in CAD software mechanism and imported in MATLAB simulink. As here with i attached file .mdl file also.
- Badges
- Science topic