Molecular weight of different molecules?

11 November 2017 1 9K Report

I want to know the molecular weight of some molecules in mice (such as Dopamine receptors, Tyrosine hydroxylase. Is there any site for this?

Gregory Dressler

If you are asking about the MW of the proteins then just look up the proteins of interest on EMBL or any other genome browser to get the number of amino acids. MW is about 110 x aa number. Although the proteins can run slighlty different on a SDS/PAGE gel, this is a good approximation.

Badges
Science topic

Similar topics
Eutheria
Rodentia
Muridae
Murinae
Mice

More Abdelraheim Attaai's questions See All

How to prepare hippocampus (HC) for ELISA & WB?

I am working on scopolamine induced Alzheimer rat model. I want to keep the HC of one hemisphere for ELISA & WB. My Questions are: 1) does single HC will be enough for application of both...

11 December 2019 1,119 3 View

Could anyone recommend certain dopamine receptor 1 (DrD1) primer for regular PCR ?

I am wondering If anyone have used dopamine receptor 1 (DrD1) and got clear bands after running in gel. I have used one which sometimes gives one band, sometimes give additional band near the...

06 July 2017 647 4 View

What are the differences between using activated Caspas3, AnnexinV or Tunnel assay?

What are the differences between using activated Caspas3, AnnexinV or Tunnel assay for evaluation the apoptotic cells? and which is better for double immunolabelling?

05 June 2017 9,839 6 View

Is Olig2 a master marker for all oligodendrocytes?

Does OLig2 ab stain all oligodendrocytes? i.e. progenitor, postmitotic and mature oligodendrocytes in embryonic , postnatal and adult brain. I mean is there a single antibody that can stain all...

10 November 2016 7,203 8 View

Did anyone try to remeasure the RNA samples after thawing?

if yes, Did the conc.have the same values?

08 September 2015 1,718 6 View

Are there specialized microglia knockout mice?

I ask about possible specialized knock out for microglia only but not other macrophages, because most researchers use knock out mice for microglia but it also affect other macrophages.

02 March 2015 6,835 9 View

Does anybody complete the immunofluorescent staining of vibratome brain sections in only one day?

Brain sections? If so, how many hours could I incubate the primary antibody? and in which temp (4 degrees or room temp ?

11 December 2014 584 1 View

What is the best RNA isolation kit?

I need RNA isolation kit which yields the maximum amount of RNA from low number cells. Thank you in advance for your suggestions.

01 January 1970 2,859 12 View

Does anyone have used any anti-Iba1 other than rabbit for IHC?

I am looking for an alternative to the Rabbit-Anti-Iba1. I would prefer an antibody which does not need antigen retrieval, because I have other rabbit antibodies for double labelling which are...

01 January 1970 1,643 3 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

How can I measure MMP-1 protein activity or protein level from liver tissue?

Instead of checking only the mRNA level, I want to check the active protein level of MMP-1 in Liver tissue from mice. How can I do that?

03 March 2021 1,763 2 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

Does anyone know HRM channel in a 2 plex QIAGEN Rotor- Gene Q qPCR can be used as a separate channel?

I am going to have 3 different probes in my qPCR work that I am going to do. But I realized that the machine we have in the lab is a Rotor-Gene Q 2plex HRM Platform, saying it has green, yellow,...

01 March 2021 8,544 1 View